User manual EPSON TM-U950 BROCHURE

[. . . ] Neither Seiko Epson Corporation nor its affiliates shall be liable to the purchaser of this product or third parties for damages, losses, costs, or expenses incurred by purchaser or third parties as a result of: accident, misuse, or abuse of this product or unauthorized modifications, repairs, or alterations to this product, or (excluding the U. Seiko Epson Corporation shall not be liable against any damages or problems arising from the use of any options or any consumable products other than those designated as Original EPSON Products or EPSON Approved Products by Seiko Epson Corporation. NOTICE: The contents of this manual are subject to change without notice. Product Name: TM-U950A/TM-U950B/ TM-U950D Model Name: M188A/M188B/M188D The following standards are applied only to the printers that are so labeled. [. . . ] This section presents important information intended to ensure safe and effective use of this product. The symbols in this manual are identified by their level of importance, as defined below. Cautions must be observed to avoid minor injury to yourself or damage to your equipment. Shut down your equipment immediately if it produces smoke, a strange odor, or unusual noise. Immediately unplug the equipment and contact your dealer or a Seiko Epson service center for advice. If water or other liquid spills into this equipment, do not continue to use it. Unplug the power cord immediately and contact your dealer or a Seiko Epson service center for advice. Do not connect cables in ways other than those mentioned in this manual. equipment may fall or collapse , causing breakage and possible injury. To ensure safety, unplug this product before leaving it unused for an extended period. Do not connect a telephone line to the drawer kick out connector; otherwise, the printer and the telephone line may be damaged. Open the ribbon cassette cover by using the tabs on the sides of the cover, as shown in illustration D. Turn the knob two or three times in the direction of the arrow, as shown in illustration E. Insert the ribbon in the position shown in illustration F and push the ribbon cassette down until it clicks. Note: Make sure the ribbon is installed between the print head and the platen without wrinkles or creases. Again turn the ribbon cassette's knob 2 or 3 times in the direction of the arrow and close the ribbon cassette cover. Be careful not to touch the print head with your fingers when turning the ribbon cassette knob because the print head is hot and you might be burned. When you replace the ribbon casette, lift the left side of the ribbon cassette first; then lift the whole ribbon cassette. Using scissors, cut the leading edge of the roll paper, as shown in illustration G. Turn on the printer and open the roll paper cover by using the tab, as shown in illustration H. Type A only: Open the unit by using the unit open lever, as shown in illustration I. Note: Note the direction the paper comes off the roll, as shown in the illustration G. [. . . ] Feed the paper with the FEED button so that the paper is taken up by the spool. Close the roll paper cover and tear off the roll paper with the manual cutter, as shown in illustration O. Note: Do not open the roll paper cover during printing or paper feeding. When using the printer, be sure to cut the roll paper with the manual cutter after paper feeding is complete. [. . . ]