User manual FIESTA D19011 ASSEMBLY

[. . . ] Hazardous Fire or Explosion may result if these instructions are ignored. If odor continues, immediately call your gas supplier or your fire department. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. [. . . ] Combustion by-products produced when using this product contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. Perform the leak test outdoors in a well ventilated area, away from any open flame, heat, or ignition sources. If bubbles are formed there is a leak that must be eliminated before you proceed. Attempting to light burner with the lid closed may cause an explosion. Hold lighted match up through lighter/ventilation hole located in center of bottom shell, while turning regulator valve knob to light position. Preheat grill for 5 minutes on high before use with lid closed, then turn control to desired level for cooking. If burner flame goes out when the unit is in use, immediately turn gas control to "OFF". Open lid and wait 5 minutes for gas to clear before relighting burner. Do not expose any part of your body directly above cooking area when lighting. Before cooking for the first time, operate the grill 15 minutes on high with top closed. Your grill will cook for approximately 2 hours with the burner set on high, using one 16. To help keep dirt out of the propane bottle probe, storage in heavy plastic bag is recommended. Warrants its gas barbeque, subject to the terms set forth below, to be free from defects in materials and workmanship during the period of One (1) year from date of manufacture*. All other costs including labor, transportation, postage and other incidental service costs are your responsibility. all warranty service and/or replacement parts must be performed by the Customer Service Department of Fiesta Barbeques Limited. All Warranty replacement or repair shall be subject to terms and conditions of this warranty for the remainder of the original period of coverage. [. . . ] Position heat plate over screws so nuts are on inside of plate flanges. Assemble regulator to burner: with knob pointing down, align slot in end of regulator with dimple in burner, push in and turn to lock in regulator. How to Order Spare Parts: When ordering, always give the following information: 1. [. . . ]