User manual FISHMAN ELLIPSE MATRIX BLEND

[. . . ] Plug in · Connect the Ellipse Matrix Blend to your amplifier or PA with a ¼inch instrument cable. [. . . ] Microphone T rim The microphone and pickup levels are preset at the factory and do not require adjustment. However, a microphone trim control (recessed below the Volume slider) may be adjusted to alter the microphone and pickup balance. Set the Blend slider to the center position and adjust the trim control as necessary. 4 Voicing Switch This switch selects how the pickup is voiced. Move the Voicing Switch towards the Volume slider for bass boost and towards the Blend slider for a flat response. Choose the setting that works for your instrument and your performance requirements. Here are some guidelines: · The boosted bass voicing (switch towards the Volume slider) compliments solo guitarists and singers who accompany themselves, especially with smaller instruments. · The flat voicing (switch towards the Blend slider) cuts through the mix if you play in a band. It does a good job controlling boominess and low frequency feedback onstage, especially with full-size guitars. 5 Battery Replacement When the battery is low you will hear distortion as you play through the Ellipse system. [. . . ] 1k Ohm +7dBV 111dB -104dB 50Hz ­ 20kHz +6dB @ 90Hz 50Hz ­ 20kHz -3dB @ 350Hz All specifications subject to change without notice. 7 www. fishman. com 513-300-029 Rev C 9-08 [. . . ]