User manual FLUKE FILL KIT PROCEDURE FOR E-DWT INSTALLATION

[. . . ] Fill Kit Procedure for E-DWT P/N 3462475 Instruction Sheet Fill kit for E-DWT, P/N 3462475, includes: DESCRIPTION Aluminum Handheld Vacuum Pump Fluid Reservoir Kit, 4. 5 OZ Tubing, 1/4" Id, 3/8" OD Tubing, Pfa, 1/4" OD Hose Clip Elbow, 1/4 Push-In X 10-32unf Slide Valve, Knurled Sleeve, Brass 10-32 Hex Extension Adapter, 2 In Length, Brass O-Ring, Fluorocarbon (Fkm), Brown QTY 1 PART NO. [. . . ] The tubing will slide onto the barbed connection tightly without a hose clip. Procedure Plug the E-DWT-H test ports: Use the provided DH500 plugs to plug both of the DH500 female test ports on top of and on the rear of E-DWT-H. Figure 2: Fill kit connected to reservoir port Thread the brass standoff into the port at the bottom of the reservoir. Open the slide valve by sliding the shuttle up: Valve operation is UP-OPEN and DOWN-CLOSED when the kit is in the orientation shown in Figure 1. Read the vacuum on the gauge attached to the hand pump. Close the slide valve by sliding the shuttle down. Liquid will be drawn into the evacuated system. Figure 3: Evacuating the E-DWT-H with fill kit Fluke. Keeping your world up and running. ® Fluke Corporation DH Instruments Division 4765 East Beautiful Lane Phoenix, AZ 85044-5318 USA Ph: 602. 431. 9100 Fax: 602. 431. 9559 Fluke Europe B. V. PO Box 1186, 5602 BD Eindhoven, The Netherlands For more information call: In the U. S. A. [. . . ] 7/2009 3463534A D-EN-N Modification of this document is not permitted without written permission from Fluke Corporation. [. . . ]