User manual FLUKE MPG2-H WITH PG7302 INSTALLATION

[. . . ] Interconnection Kit For MPG2-H with RPM4 or PG7302 P/N 3367797 Instruction Sheet Interconnection kit for MPG2-H with RPM4 or PG7302, P/N 3367797, includes: DESCRIPTION PRESSURE RATING QTY PART NO. a RPM4 ­ Install glands and collars onto the 12 in. x 1/8 in. (127 mm x 3 mm), DH500, flexible Elbow DH500 Tee DH500 Union DH500 Plug DH500/DH700 Adaptor, DH500F x 1/8 in. [. . . ] Install the free end of the center nipple into RPM4 or PG7302: The center, 2. 75 in. Do not tighten the gland in the RPM4 or PG7302 yet, since it will be tightened when the system is primed. Install a DH500M to 1/8" NPT male adaptor in the DUT if necessary: The 1/8 in. If you intend to use the adaptor, 1 1 1 1 2 3068361 3068501 3068520 3068470 3068785 Introduction This kit provides the tubing and fittings necessary to connect an MPG2-H pressure controller to either an RPM4 reference pressure monitor or to a PG7302 piston gauge, and also to a device under test. This document contains instructions for connecting the fittings and tubing. Installation of Interconnections Remove Plugs from MPG2-H, Tee, Union and RPM4 or PG7302: Unscrew the glands from the test ports of the MPG2-H and RPM4 or PG7302. nipple: Slide a gland over a nipple so that the threads of the gland face outward. Use collars and glands from tee, elbow and union. wrap Teflon® thread tape around the NPT threads three times and install it into the DUT. The DUT will be connected to the test line with the remaining flexible 5 in. This nipple can be installed either in the 3-way tee, or in the port on top of the MPG2-H. Tighten the gland in the tee or MPG2-H, but do not tighten the gland that connects to the DUT. Plug the open test port: There is an open test port either on the top of the MPG2-H, or on the 3-way tee. Prime the system, tighten fittings: Pump fluid through the nipples by using the MPG2-H. [. . . ] High pressure systems should be assembled and operated only by personnel who have been instructed in proper safety practices. · ALWAYS use external tubing and fittings rated for pressures equal to or greater than the maximum pressure which MPG2-H will be used to generate. Figure 1: Nipples installed in 3-way tee, elbow and union Document 3367676 081001 DH Instruments, a Fluke Company 4765 East Beautiful Lane Phoenix AZ 85044-5318 USA Tel 602. 431. 9100 Fax 602. 431. 9559 dhi@dhinstruments. com www. dhinstruments. com [. . . ]