User manual FLYMO EASICUT 600XT

[. . . ] Never use the product unless the guards provided by the manufacturer are in the correct position. Read the user instructions carefully to make sure you understand all the controls and what they do. Do not operate in the rain or leave the product outdoors while raining. Remove plug from mains before adjusting, cleaning or if cable is entangled or damaged Never pull on the cable to disconnect any of the plugs Do not pull cable around sharp objects. [. . . ] Do not touch the electric cable until the electrical supply has been disconnected. Your electric cable must be uncoiled, coiled cables can overheat and reduce the efficiency of your product. Mains cables and extensions are available from your local Approved Service Centre. Do not wear loose clothing or jewellery which can be caught in moving parts. Thoroughly inspect the area where the product is to be used and remove all wires and other foreign objects. Before using the machine and after any impact, check for signs of wear or damage and repair as necessary. Always ensure the hand guard supplied is fitted before using the product. Never attempt to use an incomplete product or one with an unauthorised modification. Never operate the product with damaged guards or without guards in place. Whilst using the product always be sure of a safe and secure operating position. Keep hands and feet away from the cutting Means at all times and especially when switching on the motor. Remove the plug from the mains :before leaving the product unattended for any period; before clearing a blockage; before checking, cleaning or working on the appliance; if you hit an object. Do not use your product until you are sure that the entire product is in a safe operating condition; if the product starts to vibrate abnormally. Keep all nuts, bolts and screws secure to be sure the product is in safe working condition. Be careful during adjustment of the product to prevent entrapment of the fingers between moving blades and fixed parts of the machine. After use the product should be stored using the blade cover provided. Awareness of the environment must be considered when disposing of `end-of-life' product. If necessary, contact your local authority for disposal information. [. . . ] Failures due to the following are not covered, therefore it is important that you read the instructions contained in this Operator's Manual and understand how to operate and maintain your machine: Failures not covered by guarantee * Replacing Cutting Line. * Failures as a result of not using the product in accordance with the instructions and recommendations contained in this Operator's Manual. * The following items listed are considered as wearing parts and their life is dependent on regular maintenance and are, therefore not normally subject to a valid warranty claim: Blades, Electric Mains cable, * Caution!Husqvarna Outdoor Products does not accept liability under the warranty for defects caused in whole or part, directly or indirectly by the fitting of replacement parts or additional parts that are not either manufactured or approved by Husqvarna Outdoor Products, or by the machine having been modified in any way Genom att se till att denna produkt omhändertas ordentligt kan du hjälpa till att motverka potentiella negativa konsekvenser på miljö och människor, vilka annars kan orsakas genom oriktig avfallshantering av denna produkt. [. . . ]