User manual FLYMO EHT450S

[. . . ] The operator is responsible for following the warning and safety instructions in this manual and on the Hedgetrimmer. Explanation of Symbols on the Easi-Trim 420, 450s, 530, 530s. Before use, examine cable for damage, replace it if there are signs of damage or ageing. Do not use the Hedgetrimmer if the electric cables are damaged or worn. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. [. . . ] Never operate the Hedgetrimmer with damaged guards or without guards in place. Whilst using the Hedgetrimmer always be sure of a safe and secure operating position. Keep hands and feet away from the cutting means at all times and especially when switching on the motor. Remove the plug from the mains :before leaving the Hedgetrimmer unattended for any period; before clearing a blockage; before checking, cleaning or working on the appliance; if you hit an object. Do not use your Hedgetrimmer until you are sure that the entire Hedgetrimmer is in a safe operating condition; if the Hedgetrimmer starts to vibrate abnormally. Keep all nuts, bolts and screws secure to be sure the Hedgetrimmer is in safe working condition. Be careful during adjustment of the Hedgetrimmer to prevent entrapment of the fingers between moving blades and fixed parts of the machine. After use the Hedgetrimmer should be stored using the blade cover/storage holder provided. X 7. Insert T-shaped hooks of cable holder into Tshaped holes on the underside of your Hedgetrimmer. (A) Preparation Instructions 2. Secure by pulling the cable holder, in the direction shown, away from the Hedgetrimmer, blades until it locks into position. (B) Starting and Stopping Before starting your Hedgetrimmer. Form a loop in mains cable and push the loop through the hole in the cable holder as illustrated in Fig. Connect female extension cable connector to the male plug lead on your product. (E) Connect to mains and switch on Remove blade cover/storage holder as illustrated in Fig. Both switch levers need to be held in the operating position (G) for the product to start. 2. To stop, release one switch lever (H). ENGLISH - 2 How to Use How to Use your Hedgetrimmer 1. Inspect area to be cut before each use remove objects which can be thrown or become entangled in the cutting blades. Hold handle firmly with both hands and stand in a secure and stable position. Allow the cutting blades to reach full speed before entering the material to be cut. Always work going away from people and solid objects such as walls, large stones, trees, vehicles etc. Disconnect the Hedgetrimmer from the power source and clear jammed debris from the cutting blades. (J) A slight downward tilt of the cutting blades in the direction of motion gives the best cutting results. Side Cutting When trimming the sides of the hedge, begin at the bottom and cut upwards (K), tapering the hedge inward at the top. [. . . ] KG, Industriezeile 36, 4010 LINZ, Tel: 0732 770101-0, Fax: 0732 770101-40, email: office@husqvarna. co. at Internet: www. husqvarna. at Electrolux Poland Sp. Husqvarna, Wysockiego 15 b 03-371 Warszawa Tel:- (0-22) 330 96 00, Fax: (0-22) 330 96 35 Husqvarna-Ges. m. b. H. KG, Industriezeile 36, 4010 LINZ, Tel: 0732 770101-0, Fax: 0732 770101-40, email: office@husqvarna. co. at Internet: www. husqvarna. at Electrolux Slovakia s. r. o. , Borova Sihot 211, 033 01 Lipt. Hradok Tel: 044 522 14 19, Fax: 044 522 14 18, www. flymo-partner. sk Flymo Schweiz/Suisse/Suizzera Tel 062 889 93 50 / 889 94 25, Fax 062 889 93 60 / 889 94 35 Electrolux Outdoor Products, Sverige Tel: 036 ­ 14 67 00, Fax: 036 ­ 14 60 70 Electrolux Outdoor Products United Kingdom Tel: 01325 300303, Fax: 01325 310339 DANMARK DEUTSCHLAND ESTONIA FRANCE FINLAND SUOMI ITALIA IRELAND MAGYARORSZÁG NORGE NEDERLAND ÖSTERREICH POLSKA SLOVENIJA SLOVENSKA SCHWEIZ/SUISSE/SUIZZERA SVERIGE UNITED KINGDOM Electrolux Outdoor Products Aycliffe Industrial Park NEWTON AYCLIFFE Co. Durham DL5 6UP ENGLAND Telephone - (00) 44 1325 300303 Fax - (00) 44 1325 310339 UK Telephone - 01325 300303 Fax - 01325 310339 Our policy of continuous improvement means that the specification of products may be altered from time to time without prior notice. [. . . ]