User manual FUTABA 10CG

[. . . ] 10CAG/10CHG/10CG-2. 4GHz 10-CHANNEL RADIO CONTROL SYSTEM INSTRUCTION MANUAL Technical updates and additional programming examples available at: http://www. futaba-rc. com/faq Entire Contents ©Copyright 2009 1M23N21007 TABLE OF CONTENTS Curve, Prog. 71 INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Other Equipment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 75 Introduction to the 10CG . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If channel 5 is nulled or used as the second aileron servo, the safety function will not be available. · Trainer Safety: SNAP-ROLL is automatically disabled when the trainer function is activated. 59 GOAL of EXAMPLE: STEPS: INPUTS: Activate SNAP-ROLL . (Note: using negative percents can G (10CHG) is down, meaning snap change any of the 4 snap directions. example, change snap 1 to "down" by is in the down position. ] Notice MIX reading is still OFF. (Ex: Change to the left/ down snap and adjust rudder to 105%. ) C C to SW1. View additional setups on the internet:www. futaba-rc. com\faq\. 60 MIXES: the backbone of nearly every function Mixes are special programs within the radio that command one or more channels to act together with input from only one source, such as a stick, slider or knob. A 100% linear mix tells the slave servo to do exactly what the master servo is doing, using 100% of the slave channel's range to do so. A 50% linear mix would tell the slave servo, for example, to move to 50% of its range when the master's control is moved 100%. 52. ) · Offset: An OFFSET servo is moved a set percent of its range. An example of this is AIRBRAKE · Curve: Curve mixes are mostly used in helicopters, but may also be used in airplanes and gliders. An example is THROTTLE-NEEDLE mixing, where the in-flight needle's servo is moved, changing the mixture, as the throttle servo is moved. 65. ) · Delay: Delay mixes are part of a few very special functions that make the servo move to its desired range more slowly. 66) and the elevator delay in AIRBRAKE are two examples of this (see p. 103) is another example that slows the servo movement to the trim settings for the other conditions. to use. Additionally, the 10CG ACRO and GLID programs both provide 4 linear and 4 curve fully-programmable mixes (HELI functions, etc. Let's look quickly at a few examples that are features we've already covered. Additional examples: · Exponential is a preprogrammed curve mix that makes the servo's response more (+) or less (-) sensitive around center stick (works in conjunction with dual rate, a linear mix that adjusts the total range). These tell the throttle servo, when below a certain point, to move toward idle an additional set percentage to help close the carburetor. · ELEV-TO-FLAP model loop even tighter than it can on elevator alone. 62. ) · THROTTLE-NEEDLE mixing is a curve mix (like PROG. MIX 5 to 8 · THROTTLE DELAY mixing is a pre-programmed delay mix that slows down the response of the CH3 servo. 66. ) Next, we'll get an in-depth look at some pre-programmed mixes ( simplicity) we've not covered yet, and last, look at the fully-programmable mix types. 61 ELEV-FLAP mixing (ACRO GLID): ELEV-FLAP ELEVATOR STICK is moved. It is most commonly used to make tighter pylon turns or squarer corners in maneuvers. [. . . ] 40 THROTTLE HOLD: (HELI) makes the throttle servo non-responsive to THROTTLE STICK position, and moves the throttle to idle. NOTE: THR-HOLD must be activated, then the default pitch curve adjusted properly. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 99 THROTTLE MIX (HELI altitude when the rotor is tilted by aileron, elevator, and rudder controls. [. . . ]