User manual FUTABA MC230R

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual FUTABA MC230R. We hope that this FUTABA MC230R user guide will be useful to you.


FUTABA MC230R : Download the complete user guide (162 Ko)

Manual abstract: user guide FUTABA MC230R

Detailed instructions for use are in the User's Guide.

[. . . ] 1M23N08202 Before using your MC230CR, please read this manual thoroughly and use the MC230CR properly and safely. After reading this manual, store it in a safe place. MOUNTING PRECAUTIONS Install the receiver and receiver antenna at least 1cm away from the amp, motor cord, power cord, Nicd battery, and other parts that carry a high current. [. . . ] ·Power requirement: Nicd battery 6~7 cells (7. 2~8. 4V) ·PWM frequency: 1. 5kHz (fixed) ·Setting: One-touch input by pushbutton switch. ·Current capacity (FET rating): Forward=90A, reverse=45A ·Case size: 27. 1x333x12. 8mm (excluding protruding parts) ·Silicon cord gauge size: AWG16 equivalent ·Weight: 44g (including connectors and switches) ·BEC voltage: 6. 0V Symbol: ; Prohibited ; Mandatory Meaning Procedures which may lead to a dangerous condition and cause death or serious injury to the user if not carried out properly. Procedures which may lead to a dangerous condition or cause death or serious injury to the user if not carried out properly, or procedures where the probability of superficial injury or physical damage is high. Procedures where the possibility of serious injury to the user is small, but there is a danger of injury, or physical damage, if not carried out properly. SET UP Neutral, high, and brake MAX points setting Set the steering angle adjustment function (ATV) to 100% and the ABS function and acceleration function to OFF using the transmitter throttle channel function. If the steering angle is too large or the ABS and acceleration functions are on, erroneous operation may occur. *When using the ABS function, after setting up the MC330CR, stop the reverse function, then turn on the ABS function. If the ABS function is on, the MC330CR cannot be set up correctly. PROTECTION CIRCUIT OPERATION The following protection circuits are built into the MC230CR. When a protection circuit operates, remove the cause before operating the model again. Overcurrent protection Heat protector Low voltage operation When an overcurrent flows due to an output short circuit, etc. , the overcurrent protection circuit automatically limits the current to protects the FET. is detected, the heat protector operates so that the speed is gradually reduced. When the FET temperature drops, the heat protector automatically resets. [. . . ] (The reverse function is switched alternately. ) (Amp power left on alarm) Blinks. *When the transmitter if OFF, this function is not performed in environments such that the servo operates erroneously. When the transmitter power was turned off first. BRAKE/REVERSE OPERATING INSTRUCTIONS Operation can be switched to reverse operation by returning the throttle trigger (or throttle stick) from the brake position to the neutral position. FUTABA CORPORATION * Confirmation beep only sounds when the motor was connected. Makuhari Techno Garden Bldg. , B6F 1-3 Nakase, Mihama-ku, Chiba 261-8555, Japan Phone: (043) 296-5118 Facsimile: (043) 296-5124 ©FUTABA CORPORATION 2000, 7 [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE FUTABA MC230R




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual FUTABA MC230R will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.