User manual GAGGIA TITANIUM

[. . . ] As the proud owner of the machine, you can now experience the taste of a delicious cup of espresso or cappuccino in the comfort of your own home. When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons, including the following: 1 Read all instructions and information in this instruction book and any other literature included in this carton referring to this product before operating or using this appliance. 3 To protect against fire, electric shock and personal injury do not immerse cord, plugs or appliance in water or other liquid. 4 Close supervision is necessary when any appliance is used by or near children. [. . . ] The hot water nozzle and pipe can reach high temperatures: avoid touching it directly with your hands. â· When the machine is ready to dispense coffee, direct the steam pipe (14) above the drip tray, open the "hot water/steam" knob (16) for a few instants to discharge any residual water from the steam pipe; soon only steam will issue from the nozzle. Note: if the ring nut is not securely tightened, the cappuccinatore may slip out during use. Fill 1/3 of the receptacle you wish to use to make cappuccino with cold milk. For best results when making cappuccinos, the milk and the cup used should be cold. â· Immerse the steam nozzle into the milk to be frothed and turn the knob (16); turn the container slowly with up-down movements to achieve uniform frothing (Fig. Note: Should you wish to use big cups, raise the side door and rotate the steam tube; by this way, the steam tube can be further raised (Fig. To dispense hot water using the cappuccinatore, follow the directions provided in par. ENGLISH While hot water is being dispensed, the silicone tube inside the cappuccinatore must be inserted into the grating of the drip tray. Make sure the silicone tube cannot slip out while the machine is in use. Note: Insert the tube into the grating, so that to avoid any contact with dirty water or ground coffee residues; the risk is that the drip tray contents may be sucked up. â· When you have finished using the cappuccinatore and steam, clean the cappuccinatore to remove residual milk. â· Place a container filled with fresh drinking water alongside the machine and place the tip of the intake tube inside the container. â· Proceed as if you were making cappuccino, allowing the dirty water to flow into a receptacle or directly into the drip tray. The steam may be used to froth milk for cappuccino and to heat up beverages. The dispensing tube can reach very high temperatures: avoiding touching it directly with your hands. â· Position the cappuccinatore over the drip tray, open the "hot water/steam" knob (16) for a few seconds to discharge residual water from the cappuccinatore; in a short time only steam will issue from the tube. After using the cappuccinatore, you should clean it thoroughly to ensure maximum hygiene and functionality over time. Place the intake tube in a suitable receptacle or directly into a container of milk, placed next to the machine. â· Place a cup containing previously prepared coffee beneath the nozzle of the cappuccinatore. â· Open the knob (16); frothed milk will start issuing from the cappuccinatore. â· Move the pin on the cappuccinatore to regulate the thickness of the foam; by pushing it upward you will increase its volume. [. . . ] Then the cycle stops automatically, and the display shows: This function allows you to restore all the machine operating parameters originally set by the manufacturer. Choose to activate the function by pressing "" or "" and when Note: during the set deactivation period, the machine can be restarted at any time by pressing "MENU/OK". Later, to deactivate the machine again, go into the programming mode by pressing "MENU/OK" and exit immediately by pressing "ESC". Choose whether you want to restore the factory settings by pressing "" or "" and press "MENU/OK" to confirm your selection. [. . . ]