User manual GARMIN G1000 MOONEY ANNUNCIATIONSANDALERTS PILOTS GUIDE M20M M20R

[. . . ] · System Annunciations: Typically, a large red `X' appears in windows when a failure is detected in the LRU providing the information to the window. See Section 9. 3 for more information. System Annunciation Red `X' Annunciation Window (Not Used By Mooney) Alerts Window Figure 9. 1. 1 G1000 Alerting System Softkey Annunciation 190-00444-01 Rev. A Garmin G1000 Annunciations and Alerts Pilot's Guide for Mooney M20M & M20R 9-1 ANNUNCIATIONS & ALERTS Alert Levels The G1000 Alerting System uses a single alert level for Mooney aircraft: · MESSAGE ADVISORY: A Message Advisory alert is designed to provide general information to the pilot. This alert is accompanied by a flashing ADVISORY softkey, as shown in Figure 9. 1. 2. [. . . ] serviced. Database Message Advisories Alerts Window Message Comments MFD1 DB ERR ­ MFD1 aviation database error exists. MFD1 DB ERR ­ MFD1 terrain dataThe MFD and/or PFD detected a failure in the terrain database. If problem persists, the G1000 PFD1 DB ERR ­ PFD1 terrain database system should be serviced. DB MISMATCH ­ Aviation database The PFD and MFD have different aviation database versions installed. DB MISMATCH ­ Aviation database The PFD and MFD have different aviation database types installed (Americas, European, etc). DB MISMATCH ­ Basemap database The PFD and MFD have different basemap database versions installed. DB MISMATCH ­ Terrain database The PFD and MFD have different terrain database versions installed. DB MISMATCH ­ Terrain database The PFD and MFD have different terrain database types installed Crossfill is off. Xtalk is off Install correct obstacle database version in both displays. 9-10 Garmin G1000 Annunciations and Alerts Pilot's Guide for Mooney M20M & M20R 190-00444-01 Rev. A ANNUNCIATIONS & ALERTS GMA 1347 Message Advisories Alerts Window Message GMA1 FAIL ­ GMA1 is inoperative. GMA1 CONFIG ­ GMA1 configuration The audio panel configuration settings do not match backup configuration memory. MANIFEST ­ GMA1 software misThe audio panel has incorrect software installed. GMA1 SERVICE ­ GMA1 needs The audio panel self-test has detected a problem in the unit. BACKUP PATH ­ Audio panel using The audio panel is using a backup communication path. A ANNUNCIATIONS & ALERTS GIA 63 Message Advisories (Cont. ) Alerts Window Message Comments COM1 RMT XFR ­ COM1 remote The COM1 and/or COM2 transfer switch is stuck in the enabled (or "pressed") positransfer key is stuck. If the problem persists, COM2 RMT XFR ­ COM2 remote the G1000 system should be serviced. RAIM UNAVAIL ­ RAIM is not availGPS satellite coverage is insufficient to perform Receiver Autonomous Integrity Moniable from FAF to MAP waypoints. RAIM UNAVAIL ­ RAIM is not availGPS satellite coverage is insufficient to perform Receiver Autonomous Integrity Moniable. POSN ERROR ­ RAIM has determined When a RAIM position error is detected, GPS is flagged and the system no longer GPS position is in error. DGRD GPS ACC ­ GPS position acGPS position accuracy has been degraded and RAIM is not available. NAV1 RMTXFR ­ NAV1 remote transThe remote NAV1 and/or NAV2 transfer switch is stuck in the enabled (or "pressed") fer key is stuck. If the problem perNAV2 RMTXFR ­ NAV2 remote trans- sists, the G1000 system should be serviced. [. . . ] Select the correct SLCT FREQ ­ Select appropriate frequency for approach. SLCT NAV ­ Select NAV on CDI for Set the CDI to the correct NAV receiver. NO WGS84 WPT ­ Non WGS 84 The selected waypoint [xxxx] does not use the WGS 84 datum. Cross-check position waypoint for navigation -[xxxx] with alternate navigation sources. [. . . ]