User manual GARMIN G1000 NON-AIRFRAMESPECIFIC PILOTS TRAININGGUIDE-03

[. . . ] G1000 TM pilot's training guide Garmin G1000 Pilot's Training Guide 190-00368-03 Rev. Garmin International, Inc. , 1200 East 151st Street, Olathe, Kansas 66062, U. S. A. Tel: 913/397. 8200 Fax: 913/397. 8282 Garmin AT, Inc. , 2345 Turner Road SE, Salem, Oregon 97302, U. S. A. Tel: 503. 391. 3411 Fax 503. 364. 2138 Garmin (Europe) Ltd. , Unit 5, The Quadrangle, Abbey Park Industrial Estate, Romsey, Hampshire S051 9DL, U. K. [. . . ] The next point in the approach is an intermediate fix "WILDE". As the plane approaches "WILDE" the waypoint message `NEXT DTK 072°' is displayed. As the waypoint approaches, the message is replaced by a turn advisory `TURN TO 072°'. At 2. 0 nm from the FAF (PINTO), the G1000 switches from terminal mode to approach mode. As the plane approaches the FAF, the waypoint message `NEXT DTK 072°' is displayed. Make any adjustments necessary for the final course segment (FAF to MAP). 8. As the plane crosses the FAF, the destination sequences to the MAP (RW07map, the runway threshold). Keeping the CDI needle centered, fly toward the MAP, observing the altitude minimums dictated by the approach plate. As the plane approaches the MAP, the waypoint message `ARRIVING AT WAYPOINT' is displayed. As the plane crosses the MAP, `SUSP' is displayed in the HSI and directly above the SUSP softkey, indicating that automatic sequencing of approach waypoints is suspended. A `FROM' indication is displayed on the CDI, but course guidance along the final approach course continues. 30 Garmin G1000 Pilot's Training Guide 190-00368-03 Rev. A PROCEDURES Figure 3 Flying the DME Arc and Vectors to the DME Arc 190-00368-03 Rev. A Garmin G1000 Pilot's Training Guide Reproduced with permission of Jeppesen Sanderson, Inc. Not to be used for navigation. 31 PROCEDURES Procedure 5 VECTORS TO THE DME ARC This example is en route from KSAF to KFMN on a heading of 294°, 25 miles out and ATC gives vectors to intercept the arc outbound from HIDOX. If the approach has not already been activated, be sure to do so when cleared for the approach. ATC instructs to turn left to a heading of 270° to intercept the arc. Prior to intercepting the arc the leg must be activated since the arc was not intercepted at the IAF. With the Active Flight Plan page displayed, press the FMS knob to activate the cursor. Turn the large FMS knob to highlight DME ARC and press the MENU key to display a list of options. A confirmation window is displayed with `ACTIVATE' highlighted, press the ENT key. This activates the arc leg as well as the approach. NOTE: The leg can also be activated by pressing the ACT LEG softkey. 7. As the plane approaches WILDE the waypoint message `NEXT DTK 072°' is displayed. [. . . ] The colors used to depict dangerous terrain elevations based on aircraft altitude are red and yellow. Red indicates that the aircraft is within 100 feet of or below the terrain level. Yellow indicates that the aircraft is within 1, 000 feet of the terrain. These two colors allow the pilot to look at the planned route and then decide which altitude seems optimal for the completion of the flight. [. . . ]