User manual GATEWAY M280

[. . . ] The power button has two indicators: The outside clear plastic ring indicates the port replicator power status. When the power adapter is connected to the port replicator and plugged into an outlet, the ring lights up. [. . . ] However, to ensure safe use of this port replicator, it is important that the safety instructions marked on the port replicator and in the documentation are followed. Warning Always follow these instructions to help guard against personal injury and damage to your Gateway port replicator. Setting up your port replicator Read and follow all instructions marked on the port replicator and in the documentation before you operate your port replicator. Do not use this port replicator near water or a heat source such as a radiator. The port replicator should be operated only from the type of power source indicated on the rating label. Some port replicators are equipped with a three-wire power cord to make sure that the port replicator is properly grounded when in use. If you are unable to insert the plug into an outlet, contact an electrician to install the appropriate outlet. 8 www. gateway. com Important safety information If you use an extension cord with this port replicator, make sure that the total ampere rating on the products plugged into the extension cord does not exceed the extension cord ampere rating. Care during use Do not walk on the power cord or allow anything to rest on it. The best way to avoid spills is to avoid eating and drinking near your port replicator. Unplug the port replicator from the wall outlet and refer servicing to qualified personnel if: The power cord or plug is damaged. The port replicator does not operate properly when the operating instructions are followed. The port replicator performance changes. Replacement parts and accessories Use only replacement parts and accessories recommended by Gateway. Regulatory compliance statements United States of America Unintentional emitter per FCC Part 15 This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio and television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio/TV technician for help. www. gateway. com 9 Using the Port Replicator Compliance Accessories: The accessories associated with this port replicator are: shielded video cable when an external monitor is connected. These accessories are required to be used in order to ensure compliance with FCC rules. Caution Changes or modifications not expressly approved by Gateway could void the FCC compliance and negate your authority to operate the port replicator. Canada Unintentional emitter per ICES-003 This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the radio interference regulations of Industry Canada. [. . . ] SpotShop, Spotshop. com, and Your:)Ware are trademarks of Gateway, Inc. Intel, Intel Inside logo, and Pentium are registered trademarks and MMX is a trademark of Intel Corporation. [. . . ]