User manual GENERAL ELECTRIC AGW05

[. . . ] This home standby generator requires professional installation before use. You never have to look far to find GE support and service for your generator. For quick service when you need it, keep your original receipt with this manual. Generator and engine model and serial numbers should be recorded in the installation manual. [. . . ] Keep exhaust gas from entering a confined area through windows, doors, ventilation intakes, or other openings. WARNING Exhaust heat/gases could ignite combustibles or structures resulting in death, serious injury and/or property damage. 5m) from any combustibles or structures with combustible walls having a fire resistance rating of less than 1 hour. Carefully inspect the home generator for any damage that may have occurred during shipment. If loss or damage is noted at time of delivery, have the person(s) making delivery note all damage on the freight bill and affix his signature under the consignor's memo of loss or damage. If loss or damage is noted after delivery, separate the damaged materials and contact the carrier and your installer for claim procedures. Read this operator's manual and Important Safety Instructions before operating your generator. Compare the illustration with your generator to familiarize yourself with the locations of various controls and adjustments. Pull panel outward (away) from unit while pulling panel upward and out of base. NOTICE Any attempt to crank or start the engine before it has been properly serviced with the recommended oil will result in equipment failure. Refer to Maintenance in the operator's manual and engine manual for oil fill information. Electrical load transfer DOES NOT occur during the exercise cycle (unless an utility power outage occurs during the cycle). The specific day and the specific time of day this button is pressed is programmed into the control board memory. This date and time is then used to automatically initiate the system exercise cycle. On that day and time, press and hold "SET EXERCISE" for three seconds. "SET EXERCISE" will flash until the button is pressed for three seconds, then "SET EXERCISE" will illuminate for 5 seconds, and finally turn off. For example, if you press SET EXERCISE on Sunday morning at 10:00 AM, the unit will run an immediate exercise cycle and an exercise cycle every following Sunday at 10:00 AM (+/- 1/2 hour). "Set Exercise" will only work if the unit is in the AUTO mode and this exact procedure is followed. The exerciser will need to be re-set if the 15 Amp fuse is removed or changed, or if the starting battery is disconnected. If you want to change the day and time the unit exercises, simply perform the "Set Exercise" procedure at the exact weekday and time you want it to take place. Before performing any generator maintenance, always perform the following steps: 1. Disconnect power before servicing control panel by removing the fuses from the transfer switch. [. . . ] For all warranty service, find the nearest Authorized Service Dealer in our dealer locator map at BRIGGSandSTRATTON. Some states or countries do not allow limitations on how long an implied warranty lasts, and some states or countries do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation and exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state or country to country. The warranty period begins on the date of purchase by the first retail consumer or commercial end user, and continues for the period of time stated in the table above. [. . . ]