User manual GORENJE FH451CW

[. . . ] Before connecting the appliance to the power mains, clean the inside of the appliance using warm water to which you have added some vinegar. The appliance must be connected to the power mains and grounded in compliance with the effective standards and regulations. The appliance may not be used outdoors and it may not be exposed to rain. Unplug the appliance from the power mains (remove the cord from the wall outlet/socket) before cleaning, bulb replacement, and any repairs. [. . . ] Appliance interior equipment may change according to the appliance model. Food storage time in case of fault or power failure In case of a fault in appliance operation or power supply failure, do not open the freezer chest. If the appliance is out of order for more than two days, empty the freezer and use the food or make sure it remains frozen. Relative humidity should not exceed 70% if the temperature is up to 25°C, or 75% if the temperature exceeds 25°C. Maximum environment temperature at which the appliance will still operate correctly depends on the make (class) of your appliance, as indicated on the rating plate. Environment temperature from +10°C to +32°C from +16°C to +32°C from +16°C to +38°C from +16°C to +43°C A damp cellar or basement is not an appropriate place for a freezer chest; the same applies for a balcony or other place where the appliance would be exposed to direct sunlight. The freezer chest must be placed on dry and sufficiently solid surface which allows it to stand stably and horizontally even when fully loaded. The appliance should not be integrated in a cupboard or other furniture. Allow at least 2-3 centimeter of clearance around the chest for free circulation of air. The appliance is fitted with a condenser unit which radiates Heat into the environment. The condenser unit is installed on the back wall, directly underneath the sheet metal layer of the back and front wall of the appliance. For correct operation, allow sufficient cooling of these surfaces; do not block them or line them with any objects. The wall outlet should be fitted with a ground contact (safety socket). The specified nominal voltage and frequency are indicated on the appliance rating plate. The appliance must be connected to the power mains and grounded in compliance with the effective standards and regulations. The appliance will withstand short-term deviations from the nominal voltage, but not more than +/- 6%. The appliance should not be integrated in a cupboard or other furniture. Allow at least 2-3 centimetres of clearance around the chest for free circulation of air. With models with a visible condenser unit installed on the back wall, make sure the clearance from the wall is at least 70 mm (see figure). With models with a condenser unit installed directly under the sheet metal cover on the back wall of the appliance, the clearance from the wall is defined by the hinge. A Temperature settings knob ­ Switching the appliance on/off ­ Activating the super freeze function B Signal light on: Super freeze function is activated C Signal light on: The appliance is powered (there is voltage in the appliance) D Signal light on: High temperature alarm Switching on: rotate the thermostat knob A clock wise towards the Max. When the appliance is switched on for the first time, the D signal light will be on. [. . . ] Move the appliance away from the walls ­ floor to allow better air circulation around the appliance. Make sure you removed the plastic spacers and that the food is not preventing the cover from being fully closed. Too large quantity of insufficiently cooled food will increase the temperature in the freezer chest interior. The light will go off when the food cools down to the set temperature. [. . . ]