User manual GORENJE G640AX1-236636

[. . . ] - Never leave the appliance unattended when the burners are being used. Particularly make sure that the pan handles are correctly positioned and keep a chek on foods requiring oil and grease to cook since these products can easily catch fire. - The machine must not be used by people (including children) with impaired mental or physical capacities, or without experience of using electrical devices, unless supervised or instructed by an expert adult responsible for their care and safety. - If the built-in hot plate has a lid, any spilt food should be immediately removed from this before it is opened. [. . . ] This appliance is not connected to a device able to dispose of the combustion fumes. It must therefore be connected in compliance with the above mentioned installation standards. Particular care should be paid to the following provisions governing ventilation and aeration. Gas connection must comply with the pertinent standards and provisions in force. When gas is supplied through ducts, the appliance must be connected to the gas supply system: o with a rigid steel pipe. The joints of this pipe must consist of threaded fittings conforming to the standards. The length of this pipe must be 2 meters at most and the seals must comply with the standards. When the gas is supplied by a bottle, the appliance must be fuelled by a pressure governor conforming to the provisions in force and must be connected: o with a copper pipe. The length of this pipe must be 2 meters at most and the seals must comply with the standards. This is easily available from the shops and facilitates connection with the hose nipple of the pressure governor on the bottle. The diameter of this hose pipe must be 8 mm and its length must be no less than 400 mm and no more than 1500 mm. It must be firmly fixed to the hose nipple by means of the safety clamp specified by standards. At the connection end, verify the gasproof using a soap solution, never a flame. WARNINGS: Remember that the gas inlet union on the appliance is a 1/2" gas parallel male type in compliance with EN 10226 standards. Installation of stainless steel pipe and rubber hose pipe must ensure that it is never able to touch mobile parts of the built-in cabinet (eg. Furthermore, it must not pass through compartments that could be used for storage purposes. When using a rubber hose pipe, it is essential to comply with the following instructions: - no part of the pipe must be able to touch parts the temperature of which exceeds 65K. - It must be easy to inspect the entire pipe length in order to check its state of wear. - The pipe must be replaced within the date stamped on the pipe itself. - The appliance complies with the provisions of the following EEC Directives: 90/396 + 93/68 regarding gas safety. It is essential to ensure that the room in which the appliance is installed is permanently ventilated in order to allow the appliance itself to operate correctly. The necessary amount of air is that required for regular gas combustion and ventilation of the relative room, the volume of which must not be less than 20 m3. [. . . ] Please also note that genuine spare parts are only available from our After Sales Service Centers and authorized retail outlets. The above data are printed on the data label put on the inferior part of the appliance and on the packing label. The above informations give to the technical assistant the possibility to get fit spare parts and a heavensent intervention. This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). [. . . ]