User manual HAIER AL92

[. . . ] Contact your local waste disposal center for proper disposal of an old appliance and contact your local authority or your dealer if you have any question. Please ensure that the pipework of your refrigerator does not get damaged prior to being picked up by the relevant waste disposal center, and contribute to environmental awareness by insisting on an appropriate, anti-pollution method of disposal. All these valuable materials may be taken to a waste collecting center and used again after adequate recycling. [. . . ] Do not obstruct or cover the ventilation grille of the appliance. WARNING: The plug should be accessible after the appliance positioned. . 2. Parts Bottle rack Shelf Temperature regulator and lamp Vegetable crisper The manufacturer reserves the right to improve the product from time to time without further notice. . 3. Installation The appliance must stand on even flooring. If the freezer is not level, adjust the front leveling leg to raise or lower it. Packaging materials should not be used as support of the appliance. Install the appliance in a well-ventilated room. Allow 10cm on each side and 10cm over the top of the freezer for easy installation and proper air circulation. Do not expose the appliance to direct sunlight or a heat source as cooker. >10cm >10cm To prevent electric shock, do not expose the appliance to rain or moisture. An extremely cold room is unsuitable for installation of the appliance. . 4. Basic Operation Reversible door 1. Detach the plug (6) at the left upper corner and the component (1) at the left lower corner. Detach the cover (5) of the hinge box at the right upper corner to remove the upper hinge. Insert the component (3) to the left hole of lower hinge (2) and tighten. Assemble the component (1) to the corresponding position on the right side and tighten. Assemble the upper hinge (4) to the corresponding position on the left side and tighten. After reversion of the door, open and close the door for several times to see to it that there is no unusual noise and all the screws and hinges are tightened. (5) (4) (6) (3) (2) (1) . 5. Basic Operation Please clean inner compartment of the appliance thoroughly before initial start-up. After the appliance is levelled and cleaned, allow it to stand still for 30 minutes before start-up. Start-up After the power is turned on, adjust the temperature regulator from '0' to an appropriate setting between '1' and '7'. When the regulator is set at '0', the appliance is switched off. Temperature control Use the temperature regulator (T) to adjust the inner temperature of the appliance. Remember that high figures on the regulator yield to lower degrees of temperature. Position 1-2 3-4 4-5 6-7 Application Summer, ambient temperature 25~35¡ Spring and autumn, ambient temperature 15~25¡ Winter, ambient temperature 5¡ -15¡ Fast refrigeration T 7 0 1 2 Note: When the temperature is altered, it takes some time for the temperature of the inner compartment to adjust. The period will be longer or shorter, depending on the ambient temperature, amount of food and how often the door is opened. Storing foods The inner tempetature of the refrigerator will be cold enough after one or two hours (longer if the ambient temperature is high) of non-load operation and suitable for food storage. 7 0 1 2 . 6. Operation Instructions The refrigeration compartment can be used for short-time food storage. The temperature of refrigeration compartment is about 0¡ ~10¡ , therefore the refrigeration compartment is unsuitable for long-time food storage. Foods arrangement 4 1 (1)Egg, butter (2)Pickles and condiment (3)Bottles of beverages (4)Pastries, ready-cooked meals, dairy products (5)Meat and sausage (6)Salad, fruit and vegetable 2 5 6 3 Tips for refrigeration Allow warm foods or beverages to cool down before placing them into the appliance. Clean and dry the foods to be refrigerated. Wrap or cover foods well before storing so as to avoid loss of water content and prevent odors. . 7. Operation Instructions Do not overfill the refrigerator. Foods should be placed with some space left between them and the back wall. [. . . ] Note: Do not stop the appliance frequently for the sake of its service life. . 10. Troubleshooting Before calling for services, check the following points to see if you can solve the problem yourself. Problem The appliance doesn't work. Possible cause The bulb is broken. The temperature regulator is set at '0'. The illuminating light doesn't work. Unusual noise The appliance doesn't stand level. The appliance is placed so near the wall that some part of it rubs against the wall. The compressor works continuously or the inner temperature is not low enough. Initial start-up Large amounts of foods are stored in the appliance. [. . . ]