User manual HAIER ESAM3055

[. . . ] # 1 1 MIN COOL FAN ONLY HI LOW SPEED ON OFF POWER 7 POWER Turns air conditioner off. Turn the knob so that arrow points to the cooler marks for more moderate cooling. [. . . ] Turn the knob so that arrow points to the cooler marks for more moderate cooling. Turn the SPEED mode switch to the "HI" or the "LOW" setting. Set the thermostat control to the temperature mark "FAN ONLY". Turn the SPEED mode switch to the "HI" or the "LOW" setting. Set the thermostat control to the desire temperature (the mid-point is a good starting position). If the room temperature is not satisfactory after a reasonable time, adjust the control to a warmer setting, as appropriate. While steadying the air conditioner , carefully bring the window sash down behind the upper guide of the air conditioner. WINDOW FRAME UPPER GUIDE ABOUT 1/4 BOTTOM GUIDE BASEPAN ANGLE INSTALL THE SEAL GASKET AND SASH LOCK Extend the side curtains to fill the window opening using 4 wood screws 31/32" to secure them. Stuff the sash seal between the glass and the window to prevent air and insects from getting into the room. Fasten the basepan angle, using a short screw13/32". BASEPAN ANGLE SHORT SCREW13/32" WINDOW SEAL GASKET WOOD SCREW31/32" 13 E TEMPERATUR 5 4 3 2 1 MIN COOL 6 7 8 9 10 MAX COOL FAN ONLY LOW PEED OFF POWER Always unplug your air conditioner before cleaning. The air filter behind the front grille should be checked and cleaned at least once every 2 weeks or more often if necessary. Open the inlet grille downward by pulling out the top of the inlet grille. Remove the air filter from the front grille assembly by pulling the air filter up slightly. [. . . ] Open the inlet grille downward by pulling out the top of the inlet grille. Remove the air filter from the front grille assembly by pulling the air filter up slightly. [. . . ]