User manual HAIER GDG 450 AW

[. . . ] this will simplify the installation and ensure the dryer is installed correctly and safely. NOTE: The electrical service to the dryer must conform with local codes and ordinances and the latest edition of the National Electrical Code, ANSI/ NFPA 70 or in Canada, CSA C22. NOTE: The gas service to the dryer must conform with local codes and ordinances and the latest edition of the National Fuel Gas Code, ANSI Z223. This dryer is not recommended for commercial application such as restaurants, beauty salons, etc. [. . . ] When installing a gas dryer into a manufactured home, a provision must be made for outside make up air. This provision is to be not less than twice the area of the dryer exhaust outlet. Installation must conform to current Manufactured Home Construction & Safety Standard (which is a Federal Regulation Title 24 CFR-Part 32-80) or when such standard is not applicable, with American National Standard for Mobile Homes. The following are specific requirements for proper and safe electrical installation of your dryer. Failure to follow these instructions can create electrical shock and/or fire hazard. Gas dryers are equipped with a factory installed three-prong 15 Amps ~120 Volts (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three-prong receptacle. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer's upper corner. Install a UL approved strain relief into the power cord entry hole of the mounting bracket. Attach the power cord neutral (center wire) conductor to the brass colored center terminal on the terminal block. Reattach the strain relief mounting bracket to the back of the dryer with two screws. Tighten the screws securing the cord restraint firmly against the power cord. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner. Install a UL approved strain relief into the power cord entry hole of the mounting bracket . Remove the green neutral ground wire from the green ground screw located above the terminal block. Attach the green power cord ground wire to the cabinet with green ground screw. Attach the white (neutral) power cord conductors and the green ground wire from the dryer harness to the brass-colored center terminal on the terminal block. Tighten the screws securing the cord restraint firmly against the power cord. With the dryer in its final position, adjust one or more of the legs until the dryer is resting solid on all four legs. NOTE: check to ensure power is Off at circuit breaker/fuse box before plugging the power cord into the outlet. Before operating the dryer, make sure the dryer area is clean and free from combustible materials, gasoline, and other flammable vapors. NOTE: On gas dryers, before the burner will light, it is necessary for the gas line to be bled of air. If the burner does not light within 45 seconds the first time the dryer is turned on, the safety switch will shut the burner off. [. . . ] Check if the circuit breaker needs to be reset, or if the fuse needs to be replaced. Dryer is working but not drying the clothes: · Vents should be free of obstruction. If the clothes dries unevenly clothes in the dryer need to be resorted. Dryer makes noise when drying: · Check for coins, loose change, buttons and other heavy objects that could be causing the noise. [. . . ]