User manual HAIER GRL-32POT

[. . . ] For your safety the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or loss of life. Combustible materials, gasoline, and other flammable vapors and liquids must not be stored near the dryer. Installations must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by the state, province, or region where this appliance is being installed. WARNING - To reduce the risk of fire, electric shock, or injury to persons when using your appliance, follow the basic precautions, including the following: Read all of the instructions before using this appliance. [. . . ] The more the dryer is used the more often you should check the exhaust system and vent hood for proper operation. RECOMMENDED MAXIMUMM Exhaust Hood Types Recommended Use only for short run installations In the absence of local codes, installation must conform with the National Fuel Gas Code, ANSI Z223. If codes allow, flexible metal tubing may be used to connect your dryer to the gas supply line. The gas supply line MUST have an individual manual shutoff valve installed within 6 feet (183cm) of the dryer in accordance with the National Fuel Gas Code, ANSI Z223. The dryer MUST be disconnected from the gas supply piping system during any pressure testing of the gas supply piping system at test pressures in excess of 1/2 psig (3. The dryer MUST be isolated from the gas supply piping system during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig (3. In an area where it will come in contact with curtains, thick carpet, or anything that will obstruct the flow of combustion and ventilation air. Any floor unevenness should be corrected with leveling legs located on the bottom of the dryer. A dryer installed in a bedroom, bathroom, alcove or closet MUST be exhausted outdoors. No other fuel burning appliance shall be installed in the same closet as the gas dryer. When installing the dryer in a closet with a door, a minimum of 120 square inches (774. Attach the power cord neutral (center wire) conductor to the brass colored center terminal on the terminal block. Reattach the strain relief mounting bracket to the back of the dryer with two screws. Tighten the screws securing the cord restraint firmly against the power cord. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner. Install a UL approved strain relief into the power cord entry hole of the mounting bracket . Remove the green neutral ground wire from the green ground screw located above the terminal block. Cartons covered in rugs, bedspreads or plastic sheets can become an airtight chamber and cause suffocation leading to death. The instructions in this manual and all other literature included with this dryer can not cover every possible condition and situation that may occur. Good safe practice and caution must be applied when installing, operating, and maintaining any appliance. If you are in doubt after installing, call a certified electrician to install and wire the dryer. There are four available drying temperatures to choose from: High, Medium, Low, and Air Fluff. [. . . ] Lint built up in screen will restrict airflows, which causes longer drying times. Do not use harsh or abrasive cleaners, as this could damage the dryer. Clean the duct and the vent on a regular basis to avoid clogging which could affect the efficiency of the dryer. Check if the circuit breaker needs to be reset, or if the fuse needs to be replaced. [. . . ]