User manual HAIER HDY6-1

[. . . ] Warning ­ To reduce the risk of fire, electric shock, or injury to persons when using your appliance, follow basic precautions, including the following: 1. Do not dry articles that have been previously cleaned in, washed in, soaked in, or spotted with gasoline, dry-cleaning solvents, or other flammable or explosive substances, as they give off vapors that could ignite or explode. Close supervision of children is necessary when the appliance is used near children. Before the appliance is removed from service or discarded, remove the door to the drying compartment. [. . . ] A chemical reaction occurs between copper and aluminum and can cause electrical shorts. The proper wiring and receptacle is a copper wired power cord with a copper wired receptacle. Note: Dryers operating on 208 Volt power supply will have longer drying times than operating on 240 Volt power supply. Danger: Improper connection of the equipment-grounding conductor can result in a risk of electrical shock. Check with a licensed electrician if you are in doubt as to whether the appliance is properly grounded. The dryer must be connected to a grounded metal, permanent wiring system, or an equipment-grounding conductor must be run with the circuit conductors and connected to the equipment-grounding terminal or lead on the appliance. Power Supply: 3 or 4 wire, 240 Volt, 30 Amp, 60Hz, 1 Phase Power Supply Cord Kit: (not supplied when sold in the United States) The dryer MUST employ a 3-conductor power supply cord NEMA 10-30 type SRDT rated at 240 Volt AC minimum, 30 Amp. , with 3 open end spade lug connectors with upturned ends or closed loop connectors and marked for use with clothes dryers. If being installed in a manufactured (mobile) home, the dryer MUST employ a 4-conductor power supply cord NEMA 14-30 type SRDT or ST (as required) rated at 240 Volt AC minimum, 30 Amp. , with 4 open end spade lug connectors with upturned ends or closed loop connectors and marked for use with clothes dryers. Green ground screw silver terminal Green neutral ground wire nut tighten nut to these threads Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner. After installing, if you are in doubt, call a certified electrician to install and wire the dryer. To be sure that the electrical connection is adequate and in conformance with CAN1-B149 (. This dryer is equipped with a CSA International Certified Power Cord intended to be plugged into a standard 14-30R wall receptacle. Be sure wall receptacle is within reach of dryer's final location. ⷠDo not modify the plug provided with the appliance: if it will not fit the outlet, have a proper outlet installed by a qualified electrician. 4-wire receptacle 14-30R If using a replacement power supply cord, it is recommended that you use Power Supply Cord Replacement. For further information, please reference the service numbers located in the "Assistance or Service" section of this manual. This dryer is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. Warning: Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative or personnel if you are in doubt as to whether the dryer is properly grounded. [. . . ] So the inside of the drum, especially the stainless steel pieces on the blades, must be cleaned regularly by a wet cloth. ⷠCheck if the circuit breaker needs to be reset or if the fuse needs to be replaced. Dryer is working but not drying the clothes: Vent should be free of all obstructions. If clothes dry unevenly a higher dry setting may be required or clothes in the dryer may need to be resorted. [. . . ]