User manual HAIER HR-5702

[. . . ] The cardboard box may be broken or cut into smaller pieces and given to a waste paper disposal service. The wrapping foil is made of polyethylene and the polyethylene pads and stuffing contain no fluorochloric hydrocarbon. . 2. Cautions For the purpose of safety, the appliance must be properly grounded in accordance with specifications. Inadequate repairs may result in a major source of danger for the user of the appliance. Keep high-proof beverages in airtight bottles or containers and always store in an upright position. [. . . ] Keep high-proof beverages in airtight bottles or containers and always store in an upright position. In addition, do not store any explosive substances inside the applianceIf the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. Specifications This appliance is designed for food refrigeration, making ice. If using it for industrial or commercial purpose, be sure to observe the relevant norms and regulations. WARNING: The plug should be accessible after the appliance positioned. Danger of explosion! Do not damage any parts of the appliance that carry refrigerant by piercing or perforating the refrigerant's grooves with sharp or pointed items, crushing or twisting any tubes, or scraping the coatings off the surfaces. If the refrigerant spurts out and gets into eyes, it may result in serious eye injuries. In no case should children be allowed to sit on the drawers or hang to the door. . 3. Observations The appliance can be placed with its rear panel directly against the wall. For a good air circulation, the vent grille at the back of the worktop must not be blocked, It should be placed on flat and firm ground lest it gives off higher noise than usual. Do not expose the appliance to direct sunlight or a heat source as cookers, radiators, heaters, etc. Allow warm foods or beverages to cool down before placing them into the appliance. Do not open the door more often than necessary to lessen cold air escape. For adequate air circulation, do not overfill the refrigerator. Adjust the temperature regulator in accordance with the ambient temperature and the amount of foods. 07 6 . 4. Basic Operation The appliance must stand on even flooring. If the appliance is to be placed on a soft carpet, support the appliance with a solid wood board. If the appliance is placed on the carpet directly, the high-temperature compressor may cause color fading of the carpet. Stop using the appliance if a sensation of electric shock is felt when touching the refrigerator. The appliance must be properly earthed, especially in a place of thick moisture. 5 4 3 Note: Foods in the refrigeration compartment may get frozen in following cases. After making ice, reset the temperature regulator to its original position. Lamp and lamp replacement Lamp:220-240V, 15W Lamp holder: E14 (lamps exceeding 15W must not be used) When replacing the lamp: * Unplug to disconnect the power and remove the water tray. * Press the positioning pin of the lamp with left hand, and release the shade from the lamp holder by sliding it to the right side. . 7. 5 4 6 1 3 2 iáÖÜí=pÜ~ÇÉ Defrosting/Cleaning Cleaning 1. For efficient operation, dirt and dust should be removed from back and bottom of your freezer from time to time. To clean the door seal, use mild, soapy water only. OK When a power failure is announced No defrosting Set the temperature regulator to the highest figure. No more fresh foods are to be stored in the refrigerator. Power failure Do not open the door more often than necessary. For a power failure not more than 3 hours, foods in the refrigerator can be well stored even in summer. Moving the refrigerator Unplug the appliance Take out foods and dry the water tray before moving the refrigerator. Note: Do not hold the refrigerator by its door and the piping of condensor-That's dangerous! . 8. Troubleshooting Before calling the service center, check the following points and see if you can solve the problem yourself. Problem No refrigeration Possible Causes Electrical connection is loose. [. . . ] Note: Do not hold the refrigerator by its door and the piping of condensor-That's dangerous! . 8. Troubleshooting Before calling the service center, check the following points and see if you can solve the problem yourself. Problem No refrigeration Possible Causes Electrical connection is loose. The appliance is exposed to direct sunlight or a heat source, such as heater. Some part of the refrigerator rubs against the wall or other furniture. [. . . ]