User manual HAIER HR-6752

[. . . ] 2 3 Installing the Oven. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Cautions / Warning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3/4/5 4 Rating plate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 5 Plugging in your appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Under no circumstances should the appliance be started, if it is damaged. Therefore, thoroughly check the appliance as for: Damaged packaging, indicating that the appliance may have been damaged during shipment Damaged cabinet Damaged door glass panel Visible damage to the cable / plug If you suspect any damage, please have the appliance tested by the customer support service. At all costs prevent the emission of any hazardous microwave radiation by not starting up a damaged oven. A ) a) Unpack the appliance b) Remove all objects from the inside of the oven. c) Carefully remove all plastic films and stickers from: the cabinet the door the Turntable axle - drive shaft Failure to carefully remove plastic films and stickers may lead to a fire hazard. e) Unpack the turntable (not all models are equipped with) and its undercarriage 2 English f) Place the undercarriage in the circular track on the oven interior floor g) Lay the turntable onto the undercarriage. It must be stable enough to easily support the appliance even if the oven contains goods. Leave a space of at least 10 cm between the foremost edge of the worktop and the front of the oven door. You will thus prevent the appliance from tilting forward when the door is open. Install the oven in a place where it is protected against splashing water or dripping liquids. Never expose your microwave oven to direct sunlight (overheating hazard), Do not install the appliance in the immediate vicinity of heat sources such as radiators or cookers. The controls offer user-friendly operation so that you can quickly familiarise yourself with your appliance and can optimise your use of it after studying the aforementioned and following guidelines and regulations in detail. Operating tasks are thus restricted to settings: desired cooking mode desired cooking time 2. You can pause operation at any time by: Pressing the door opening key (not all models are equipped with) respectively opening the oven door The timer will stop automatically and resumes its operation as soon as the oven door is firmly closed again or: Resetting the timer to "0" 3. Setting the operating mode (power level) Set the respective function symbol (FIG. B) according to the required power level. to around 150 W if the appliance has a total capacity of 750 W or to around 160 W if the appliance has a total capacity of 8OO W The operating mode switch can also be set between the levels, if your cooking recipe recommends a lower or higher wattage. B ) By turning the timer clockwise you can set the cooking time up to max. (depends on Mod. /Type) Please make sure you do not turn the timer over its limit. The cooking process will immediately start as soon as you move the timer from position " 0 " and the oven door is shut. Therefore, leave the door open and only close it when you have correctly entered all settings. Under no circumstances should you continue to use the appliance if you have detected any damage on the door seal or on the adjoining surfaces. The same applies to damage detected on the door itself or door hinges. [. . . ] The interior lamp may only be replaced by specially trained customer service personnel who is aware of the related dangers. It can thus also be operated easily even if the interior lamp has failed. This is not a malfunction. Instruction for use 10 Calling the Customer Support Service To ensure prompt help when needed, please have ready the following data before calling the customer support service: Appliance Type /Model (see rating plate) Date of purchase Name and location of your dealer Description of the malfunction The address and phone number of the customer support service centre responsible for your appliance can be found in the attached customer support service directory, or in the guarantee card. Otherwise contact your dealer. 11 Guarantee Please note the general guarantee terms and the guarantee period stated in the attached guarantee card. [. . . ]