User manual HAIER HSU-12HH03(B)

[. . . ] conditioner that carry refrigerant by piercing or performating the air conditioner's tubes Consult your local authorities for the name with sharp or pointed items, crushing or and address of the waste materials collecting twisting any tubes, or scraping the coatings centers and waste paper disposal services off the surfaces. out and gets into eyes, it may result in serious eye injuries. 1 Cautions Do not obstruct or cover the ventilation 7. The appliance is not intended for use by young children or infirm persons grille of the air conditoner. Do not put fingers without supervision. Young children should be supervised to ensure that they do not play with Do not allow children to play with the air the applience. [. . . ] Used to select your desired temp. HEALTH POWER/SOFT 17 24 23 18 LOCK RESET 19. Operation mode display Operation mode Remote controller Display board COOL DRY HEAT 21. HEALTH AUTO Used to reset the controller back to normal condition. Ambient temp. display When receiving the remote control signal, display the set temperature and in the rest time the room temperature is displayed and this room temperature is only for reference. Clock set When unit is started for the first time and after replacing batteries in remote controller, clock should be adjusted as follows: Press CLOCK button, "AM" or "PM" flashes. After time setting is confirmed, press SET, "AM "and "PM" stop flashing, while clock starts working. NOTE: Cooling only unit do not have displays and functions related with heating The unit do not have functions related with healthing. Hints After replacing with new batteries, remote controller will conduct self-check, displaying all information on LCD. Then, it will become normal. 4 Operation Remote controller's operation When in use, put the signal transmission head directly to the receiver hole on the indoor unit. The distance between the signal transmission head and the receiver hole should be within 7m without any obstacle as well. When electronic-started type fluorescent lamp or change-over type fluorescent lamp or wireless telephone is installed in the room, the receiver is apt to be disturbed in receivering the signals so the distance to the indoor unit should be shorter. Loading of the battery Load the batteries as illustrated. 2 R-03 batteries, resetting key (cylinder) Remove the battery cover: Slightly press " " and push down the cover. , ͬ ȡ ѡ , ʱ 7# , ҹ © , 6 ԡ ء ˾ װ ѡͬһƷ 7# , ʱ䲻ʱ, Ϊ ֹ©ҹ뽫ȡ ʹ쳣, ȡ, 6Ӻ װµء ൺ յܹ˾ ѡͬһƷ 7# , ʱ䲻ʱ, Ϊ ֹ©ҹ뽫ȡ ʹ쳣, ȡ, 6Ӻ װµء ൺ յܹ˾ Load the battery: Be sure that the loading is in line with the" + "/"-" pole request as illustrated. Put on the cover again Confirmation indicator: In disorderation, reload the batteries or load the new batteries after 6mins. Note: Use two new same-typed batteries when loading. If the remote controller can't run normally or doesn't work at all, use a sharp pointed item to press the reset key. Hint: Remove the batteries in case unit won't be in usage for a long period. It is harmful to your health in summer to go frequently in and out of places where temp. More than this, unit's load can be reduced and power consumption cut down as well. in COOL mode. o o o 9 Operation TIMER Operation Set Clock correctly before starting Timer operation You can let unit start or stop automatically at following times: Before you wake up in the morning, or get back from outside or after you fall asleep at night. TIMER ON/OFF (1)After unit start, select your desired operation mode. Every time the button is pressed, display changes as follows: POWER SOFT BLANK Stop the display at In SOFT operation mode, fan speed automatically takes"LOW" To cancel POWER operation Press POWER/SOFT button twice , POWER/SOFT disappears. Hints: During POWER operation, in rapid COOL mode, the roor will show inhomogeneous temperature distribution. Long period SOFT operation will cause effect of not too cool. 11 Operation Emergency operation and test operation Emergency Operation: Carry out this operation only when the remote controller is defective or lost. When the emergency operation switch is pressed, a" Pi "sound starts once, which means the start of this operation. In this operation, it is not possible to change the settings of temperature and air flow speed, it is Pi also impossible to do an operation by the timer. Room Designated temperature temperature More than 23 C Less than 23 C o o Timer mode Air flow Operation speed mode COOL HEAT 26 C 23 C o o CONTINUOUS AUTO CONTINUOUS AUTO If an air conditioner is a model for both cooling and heating. Cooling when the room temperature at the start of operation is above 23 C. o Heating when the room temperature at the start of operation is below 23 C o Test operation: Use this switch in the test operation when the room o temperature is less 16 C, do not use it in the normal operation. After you hear the "Pi" sound twice, release your finger from the switch, the cooling operation starts with the air flow speed setting "Hi". Pi Pi Removal of the restriction of emergency or test operation: Press once more the emergency operation switch, or manipulate through the remote controller, a "Pi" sound causes the restriction of emergency or test operation to be removed. [. . . ] Compliance to the instructions are strictly required for safety use. Installation WARNING Please call Sales/Service Shop for the Installation. Do not attempt to install the air conditioner by yourself because improper works may cause electric shock, fire, water leakage. lnstallation in a inadequate place may cause accidents. Do not install in the following place. CAUTION Connect the earth cable. Do not install in the Do not get the unit place where there is exposed to vapor any possibility of or oil steam. [. . . ]