User manual HAIER RDE 350 AW

[. . . ] this will simplify the installation and ensure the dryer is installed correctly and safely. NOTE: The electrical service to the dryer must conform with local codes and ordinances and the latest edition of the National Electrical Code, ANSI/ NFPA 70 or in Canada, CSA C22. NOTE: The gas service to the dryer must conform with local codes and ordinances and the latest edition of the National Fuel Gas Code, ANSI Z223. This dryer is not recommended for commercial application such as restaurants, beauty salons, etc. [. . . ] No other fuel burning appliance shall be installed in the same closet as the gas dryer. When installing the dryer in a closet with a door, a minimum of 120 square inches (774. Openings must be equally divided at the top and bottom of the door and airflow must be unobstructed. Dryer MUST be exhausted outside (outdoors, not beneath the manufactured home) using metal ducting that will not support combustion. If dryer is exhausted through the floor and area beneath the manufactured home is enclosed, the exhaust system MUST terminate outside the enclosure with the termination securely fastened to the mobile home structure. When installing a gas dryer into a manufactured home, a provision must be made for outside make up air. This provision is to be not less than twice the area of the dryer exhaust outlet. This dryer MUST be fastened to the floor using P/N 0030807899 Manufactured Home Installation Kit. Installation must conform to current Manufactured Home Construction & Safety Standard (which is a Federal Regulation Title 24 CFR-Part 32-80) or when such standard is not applicable, with American National Standard for Mobile Homes. The following are specific requirements for proper and safe electrical installation of your dryer. Failure to follow these instructions can create electrical shock and/or fire hazard. Some extension cords are not designed to withstand the amounts of electrical current this dryer utilizes and can melt, creating electric shock and/or fire hazard. Locate the dryer within reach of the receptacle for the length power cord to be purchased, allowing some slack in the cord. Refer to the electrical requirements in this manual for the proper power cord to be purchased. Attach the white (neutral) power cord conductors to the outer cord and the green ground wire from the dryer harness to the brass-colored center terminal on the terminal block. Tighten the screws securing the cord restraint firmly against the power cord. With the dryer in its final position, adjust one or more of the legs until the dryer is resting solid on all four legs. NOTE: check to ensure power is OFF at WARNING circuit breaker/fuse box before plugging the power cord into the outlet. Before operating the dryer, make sure the dryer area is clean and free from combustible materials, gasoline, and other flammable vapors. NOTE: On gas dryers, before the burner will light, it is necessary for the gas line to be bled of air. If the burner does not light within 45 seconds the first time The dryer is turned on, the safety switch will shut the burner off. If this happens, turn the dryer to "OFF" and wait 5 minutes before making another attempt to light. [. . . ] Dryer is working but not drying the clothes: · Vents should be free of obstruction. If the clothes dries unevenly a higher dry setting may be required, or clothes in the dryer need to be resorted. Dryer makes noise when drying: · Check for coins, loose change, buttons and other heavy objects that could be causing the noise. Full ONE Year Warranty For 12 months from the date of original retail purchase, Haier will repair or replace any part free of charge including labor that fails due to a defect in materials or workmanship. [. . . ]