User manual HAIER WDNS116BBS

[. . . ] To protect against electric shock, do not immerse the cord, plug, or any other part of the water dispenser in water or other liquids. This easy-to-use manual will guide you in getting the best use of your water dispenser. Model number Serial number Date of purchase Staple your receipt to your manual. This includes the foam base and all adhesive tape holding the accessories inside and outside. [. . . ] Note: Where a standard two-prong outlet is encountered, it is the personal responsibility and obligation of the consumer to have it replaced with a properly grounded three-prong outlet. POWER INTERRUPTIONS Occasionally, there may be power interruptions due to thunderstorms or other causes. When power has been restored, re-plug the power cord into wall outlet. This water dispenser maintains instant hot and cold water for your cooking and drinking needs. Note: The hot water faucet is equipped with a child safety lock to prevent accidental spilling of hot water. To release the hot water flow, push the child safety lock button down and as you push in the hot water button. Caution: Be careful when carrying hot water in your cup or container to avoid any injury or harm from spills. Heating Function: Heating indicator will flash on the display, until the temperature reaches the set temperature, then heating indicator will stop flashing. Heating Level: When setting the heating temperature, additional bars will be added as you increase the heating temperature from 190°F (Min) to 203°F (Max). Cooling Function: Cooling indicator will flash on the display, until the temperature reaches the set temperature, then cooling indicator will stop flashing. Cooling Level: When setting the cooling temperature, additional bars will be added as you increase the cooling (decreasing temperature) from 50°F (Min) to 43°F (Max). Anti-Overheat Indicator: When water dispenser is heating, if the hot water tank is out of water, the water dispenser will stop heating and the Anti-Overheating indicator and left 2 bars on the Heating Level and right 2 bars Cooling Level displays will flash. When the Anti-Overheating indicators flash, fill the water tank and follow Start-Up Instructions. Troubleshooting display: when the screen shows the left and right bars of the Heating Level display flashing, it shows a heating sensor problem. When the screen shows the left and right bars of the Cooling Levels display flashing, it shows a cooling sensor problem. Turn off and unplug the water dispenser then follow the Start-Up Instructions. PLEASE NOTE: You need to press the Hot/+ (#4 below) button to turn on the water heater and the Cold/- (#5 below) button to turn on the cooling compressor. When in stand-by mode, pressing the ON/ OFF button will cut off all power. Set function: While the dispenser is in stand-by mode, press and hold the Set button for 2 seconds, the display will go into Set Mode. In Set mode you will be able to set the clock time, hot water temperature and cold water temperature. - Press and hold the SET button to enter SET Mode - Press a 2nd time to set Clock Hours (Hours flashing) - Press a 3rd time to set Clock Minutes (Minutes flashing) - Press a 4th time to set Hot Water Temperature (Heating Level flashing) - Press a 5th time to set Cold Water Temperature (Cooling Level flashing) - If nothing is pressed for 8 seconds the display will automatically exit the Set Function 3. Night Light: Press the Night Light button and the light will turn ON, press it once more and the light will turn OFF. [. . . ] For the name of the nearest service center please visit our website at www. Damage from misuse, abuse, accident, alteration, lack of proper care and maintenance or incorrect current or voltage. Damage from service by other than an authorized dealer or service center. The remedy provided in this warranty is exclusive and is granted in lieu of all other remedies. [. . . ]