User manual HARMAN KARDON AVR 80

[. . . ] AVR80 manual 11/01/98 13:01 Side 1 Harman Kardon AVR80 Audio/VideoReceiver Volume VISUAL SIGNAL LEVEL CH STEREO TV LD VCR 12 AUX TEST MEMO AUTO TUNED STEREO dB kHz MHz DISP THX CINEMA PRO·LOGIC MOVIE HALL MATRIX MONO MULTI 3-LOGIC AUTO MEMO P-SCAN TAPE COPY VCR1 Aux MULTI DISP OSD Delay MODE P·SET P·Scan TUNE Mute RDS ar Mode DISP. AF PTY. Bass Treble Balance AUX Min Max Min Max L R S-VIDEO VIDEO L­AUDIO­R Owner's Manual AVR80 manual 11/01/98 13:01 Side 2 Declaration of Conformity We, Harman Kardon Europe A/S Kongevejen 194B DK-3460 Birkerød DENMARK declare in own responsibility, that the product described in this owner's manual is in compliance with technical standards: EN 55 013 EN 55 020 EN 55 022 EN 60 065 EN 60 555-2-3 Steen Michaelsen Harman Kardon Europe A/S Birkerød, DENMARK 11/95 AVR80 manual 11/01/98 13:01 Side 3 Front Panel 2 AVR80 Volume 1 VISUAL SIGNAL LEVEL CH STEREO TV LD VCR 12 AUX TEST MEMO AUTO TUNED STEREO dB * kHz MHz DISP THX CINEMA PRO·LOGIC MOVIE HALL MATRIX MONO MULTI 3-LOGIC AUTO MEMO P-SCAN TAPE COPY VCR1 AM/FM CD T-MON T·2 TV LD VCR1 VCR 2 Aux MULTI DISP OSD Delay MODE P·SET P·Scan TUNE Mute & Power Phones 6-ch direct mode Tape1 Copy RDS VCR1 Memo Clear Mode DISP. AF PTY. Bass Treble Balance AUX Min Max Min Max L R S-VIDEO VIDEO L­AUDIO­R 3 45 6 ( Ó Ô 7 8 9 )! # ~ ¯ $ % ¸ ^ Ò Ú ÛÙi ^ @ Delay # Mode $ Preset Tuning % P-Scan ^ Tune & Mute * Volume Control ( Power Ó Headphone Jack Ô 6 Channel Direct Tape 1 Copy 1 Information display 2 Remote Sensor Window 3 AM/FM Tuner Mode Selection 4 CD 5 Tape1/ Monitor 6 Tape 2 7 Video Sources 8 Aux 9 Multiroom Audio Select ) Display !OSD (On Screen Display) Ò VCR 1 Copy Ú Memo Û Clear Ù FM Mode i RDS Display ^ RDS Alternate Frequency ~ RDS Program Type Search ¯ Bass Treble ¸ Balance Front Panel Inputs Information Display ¡ VISUAL TM£¢ TEST MEMO AUTO TUNED § STEREO dB fl SIGNAL LEVEL CH STEREO TV LD VCR 12 AUX kHz MHz DISP ¶ · THX CINEMA PRO·LOGIC MOVIE HALL MATRIX MONO MULTI 3-LOGIC AUTO MEMO P-SCAN TAPE COPY VCR1 / ¡ "Visual" Indicators TM Test £ Memo ¢ Auto Tuned § Stereo fi > < , ¤ ª ¶ Volume Indication · Tuner Frequency Indication ª Main Information Display , Multi / Mode Status ¤ DISP < Copy Indicators > P-Scan fi Auto Memo fl Signal Level Indication AVR80 manual 11/01/98 13:01 Side 4 Rear Panel ­ Audio and System Connections ® ø FRONT L R 6-CH SURR. [. . . ] Press the < or > buttons q to set the volume in accordance with the option chosen in the previous menu: a. If you selected VARIABLE Volume Set, this option selects the volume level at the remote rooms when the system is first turned on in those locations. If you selected FIXED Volume Set, this is the level that will remain constant in the remote rooms. SET MULTI UP RM MENU 2 SET VOL >VARIABLE FIXED LEVEL XXdB UP LOCK TO LOCK UNLOCK MAIN MENU 9. Press the < or > buttons q to choose one of these options: ON: Choose this option if a Subwoofer SET RETURN is installed, getting its signal from `subwoofer' jack µ . OFF: Choose this option if no Figure 3 TEST OFF TONE >ON Subwoofer is present. Press ¤ q once and then SELECT r to move to SET UP MENU 2 to continue the set-up procedure. (Press ¤ twice and then SELECT if you prefer to return to the MAIN MENU. ) Figure 4 AVR80 manual 11/01/98 13:01 Side 18 ENGLISH System Configuration 18 14. When you have made a volume selection, press ¤ q to move to the next option. This makes it difficult for someone to inadvertently change the settings by causing the word LOCK to appear at the top of SET UP MENU 1. Before any further changes are made, the user must first go to SET UP MENU 2 and unlock the system. Press the < or > buttons q to choose one of these options: LOCK: Choose this option to lock the 17. At the MAIN MENU, press ¤ three (3) times until the > cursor is next to TEST TONE. When you press SELECT you will immediately hear a test noise from the front left speaker. The on screen display will change to a graphic representation of each of the speakers in your room, with one speaker position blinking. NOTE: This procedure will only operate if the AVR80 is in the THX, PRO LOGIC, MOVIE or DOLBY3 STEREO Modes. If the test tone cannot be selected, select MENU OFF in the MAIN MENU and check to see which surround mode is indicated in the front panel display. If it is not one of the four modes mentioned above, select one of the correct modes, and then select the MAIN MENU point TEST TONE by pressing ¤ and SELECT on the remote, to resume the setup. . While seated in the primary listening position in the center of the room, press SPEAKER v on the remote . Note that the sound should now come from the Center Channel speaker, and the icon for that speaker will flash on the screen. Use the ADJUST / and ADJUST ¤ buttons w on the remote to change the level of the test noise so that it appears to be equal in level to the Front Left speaker. 20. Press the SPEAKER button again, and repeat the procedure for the Front Right, Surround Right, Surround Left and Subwoofer channels. Each time, use the ADJUST / and ADJUST ¤ buttons w on the remote to change the volume level so that all speakers match, and press SPEAKER v to move to the next channel. NOTE: This test also serves as an opportunity to verify that all speakers are properly connected. [. . . ] The remote commands must be transmitted to the AVR80 via a coaxial link connected to the MULTI input oe on the AVR80's rear panel. Using the remote control in the second room press the POWER ON button to turn on the remote room feed. This will activate the multi room portion of the AVR80 whether or not it may be on in the main listening room. The initial feed to the remote room will be the last station selected by the tuner. [. . . ]