User manual HARMAN KARDON HK560

[. . . ] Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles and the point where they exit from the apparatus. Use only with the cart, stand, tripod, bracket or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Unplug this apparatus during lightning storms or when unused for long periods of time. [. . . ] Select: When listening to a tuner, press this button to alternate between auto Tune, Manual Tune or Preset Tune. Pause: When playing a CD, press this button to momentarily pause the disc. < and > (Search Buttons): Press one of < > these buttons to search fast forward or backward on a CD or Tape. | < and > | (Skip Buttons): Press one of < > these buttons to move to the next track or to the previous track on a CD or Tape. on a CD, pressing skip forward while playing the last track skips to track 1, and pressing skip back while playing track 1 skips to the last track. Pressing the Play button again pauses play momentarily, same as the Pause button. 10 + and -10: When playing a CD, press the +10 button to skip 10 tracks forward and the -10 button to skip 10 tracks backward from the track you are playing. If there are less than 10 tracks to the end or start of the CD, the last or first track is played. Folder + and Folder - : When playing a CD with MP3 files, these buttons move to the next or the previous folder with MP3 material. Repeat: When playing a CD, pressing this button once repeats the current track, shown as "Rep 1" in the CD player's display. Pressing once more repeats the entire CD, shown as "Rep all" in the CD player's display. Record Out (Front panel only) When pressing the Record out button, you will have access to the selection of the source you would like to get directed to the Record outputs. scroll through the list of record sources with the < and > buttons: CD, TUneR, aUX, CD-R, TaPe, TV and PHono until the desired source appears in the display. Whether the source is analog or Digital, the HK560 will deliver the Record signal in both domains simultaneously through both the analog (CD-R and Tape) and the Digital (Coaxial) outputs. This means that any analog Input can be recorded digitally without addition of an external analog/Digital converter. AUX TV TUNER PHONO CDR TAPE PROCESSOR UnbalancedAnalog · 10 seTUP InsTRUCTIons Setup Instructions 4. EQ2 LF+MF (Low and Mid Frequency correction): This Mode should be selected once the ezset/eQ setup has been carried out (see below). If selected before the ezset/eQ setup, it will simply provide the same result as the DsP Path, being a flat response with access to Tone Controls. The eQ2 lf + Mf mode is the second Preset available after the ezset/eQ Calibration has been carried out. This Preset is active for the low and mid frequency responses of both the main speakers and the subwoofers when it calibrates the system to the room. as a result, both the subwoofer and main speaker response curves are modified to accommodate the system response to the room. The response curve of the main speakers is corrected up to 1kHz and kept unaffected above this frequency, leaving the rest of the audio spectrum unaffected. [. . . ] To listen to headphones only, press to turn off any active speaker pair. select desired source for listening by pressing the front panel source up or down 4 repeatedly until the name of the source is shown in the Main Information Display or by pressing the desired system on button on the remote control. Please take the time to first associate physical Input jacks to source names, then press the Power button to place the amplifier in standby to have it save your preferences. With the Input setup, you may adjust bass and Treble as well as balance if you have not already done this during the setup process. [. . . ]