User manual HARMAN KARDON TU9200

[. . . ] With the purchase of the Harman Kardon TU9200 you are about to begin many years of listening enjoyment. While sophisticated systems are hard at work within the TU9200 to make all of this happen, hookup and operation are simple. To obtain maximum enjoyment from your new tuner, we urge you to take a few minutes to read through this manual. In addition, a few minutes spent learning the functions of the various controls will enable you to take advantage of all the power the TU9200 is able to deliver. [. . . ] 9 Memory Button: Press this button to open the memory position that stores a preset location in the tuner. (See page 9 for more information on tuner presets. ) A Standby/Power Off: Press this button to turn the unit off (to Standby). 0 A 1 2 3 4 5 8 7 6 9 0 Standby/Power On 1 Numeric Keys 2 Clear Button 3 Info/RDS Button 4 Auto Tuning Button 5 Scroll Button 6 REMOTE CONTROL FUNCTIONS 6 Function/FM Mode Selector 7 Band Selector 8 Select Button 9 Memory Button A Standby/Power Off Installation and Connections Audio Connections After unpacking the unit and placing it on a solid surface capable of supporting its weight, you will need to make the connections to your pre amplifier or integrated amplifier. Audio Equipment Connections We recommend that you use high-quality interconnect cables when making connections to source equipment and recorders to preserve the quality of the signals. When making connections to audio source equipment it is always a good practice to unplug the unit from the AC wall outlet. This prevents any possibility of accidentally sending audio or transient signals to the speakers that may damage them. Connect the analog output of the TU9200 to the tuner input of your pre amplifier or integrated amplifier. For DAB signals, connect the optical or coaxial digital output of the TU9200 to an optical digital audio input of your pre amplifier or integrated amplifier, if available. The FM antenna may be an external roof antenna, an inside powered or wire lead antenna or a connection from a cable system. Note that if the antenna or connection uses 300-ohm twin-lead cable, you need to use a 300-ohm-to-75-ohm adapter to make the connection. The strength of the incoming signal can be shown on the Information Display by pressing the Select button A8. The more segments are visible in the lower display line, the stronger the signal. The sections will be shown on the lower display line in the Information Display. To enter a section and see the options, press the Select Button Select button A8. You can scroll through the options with the Control Ring and activate an option by pressing the Select Button once that option is shown on the Information Display. 3. Turn the Control Ring, until the desired station preset is shown in the Information Display. The desired preset can also be entered with the Numeric Keys on the remote control 1. Within 4 seconds, press the Memory Button again to store the station in the memory. Information settings The DAB signal contains besides the radio station additional information. This information can be made visible in the lower display line of the Information Display 6. Dynamic Label Segment (DLS): scrolling text, supplied by the broadcaster. Multiplex Name: will show the name of the multiplex of the broadcaster. Signal Error Rate: In this section you can see the level of correction the TU9200 is applying to the DAB signal to maintain the audio quality. [. . . ] · A Radio Text message, containing special information from the broadcast station. Note that this message will scroll across the display to permit messages longer than the positions in the display. It will take 3 seconds for the text message to appear, in the meantime the word RDS RADIO TEXT will flash in the display. If no Radio Text is available, the display will show the Program Service (Station Name). [. . . ]