User manual HAUPPAUGE WINTV-HVR-1800 MCE-KIT

[. . . ] WinTV Media Center Kit Quick Installation Guide WinTV-HVR-1600 MCE-Kit WinTV-HVR-1800 MCE-Kit © Hauppauge Computer Works, Inc. Hauppauge Computer Works, Ltd techsupport@hauppauge. com support@hauppauge. co. uk www. hauppauge. com Included with the WinTV Media Center Kits: · WinTV-HVR-1600 PCI board or WinTV-HVR-1800 PCI Express board with NTSC and ATSC tuners, MPEG-2 hardware audio/video compressor for NTSC TV and one FM radio receiver. [. . . ] If you are using a cable TV or satellite TV set top box, connect it to the WinTV-HVR through either SVideo or Composite connector on the WinTV board, or connect a coax cable from the RF Out on your set top box to the TV input on the WinTV board. Media Center will automatically detect which method you are using to connect the WinTV to the set top box. WinTV-HVR-1600 WinTV-HVR-1800 Board connectors FM Radio Connector input TV Connector for Cable TV input Digital TV Connector for ATSC/QAM digital TV S-Video input Left audio input Right audio input Audio and video from an external A/V device (satellite TV receiver, cable TV box, VCR, camcorder, camera, DVD player) can be brought into the WinTV-PVR via the back panel connectors. If your A/V device uses S-Video, connect to the S-Video input on the WinTV board. If your video device uses composite video instead of SVideo, use the yellow RCA jack. Audio input from an external A/V device can be brought into the WinTV board via the white and red audio input jacks. Step 2: Installing the WinTV-HVR Windows Vista driver After installing the WinTV-HVR in your PC, boot Windows. Insert the WinTV-PVR Installation CD-ROM in your PC's CD-ROM drive. Make sure Install the software automatically (Recommended) is 2 checked. When the driver is installed, click Close. Found New Hardware in Windows XP Found New Hardware in Vista Step 3. Install the Media Center Remote control receiver/blaster The Media Center remote control receiver/blaster box is a small USB device which both receives remote control commands and transmits commands via its IR Blaster to change channels on a cable TV or satellite set top box. To install the Media Center remote control receiver/blaster, simply plug one end of Media Center remote The WinTV-HVR-1600 board Start button IR transmitter cable USB cable Media Center remote control receiver/blaster box 3 the supplied USB cable into the Media Center remote control receiver/blaster box and the other end into any USB port on your Vista Home Premium, Ultimate or Windows XP Media Center PC. Media Center will automatically load the drivers for the MCE remote control. [. . . ] The Program Guide Set Up Wizard will move you through the completion of the Program Guide set up. When you are finished with the Program Guide Setup, click the MyTV button on your Media Center remote control to start watching TV. Troubleshooting Removing the WinTV driver If you ever need to remove the WinTV-PVR driver, run HCWClear. EXE from the WinTV-PVR Installation CD-ROM. 4 [. . . ]