User manual HELIX DARK BLUE 10 DATASHEET

[. . . ] Always make sure the speaker will easily fit into the intended mounting location and that there is adequate cavity depth to accept the magnet structure. Check for adequate clearance between speaker and window, window crank, power window mechanism, seat, glove box, rear deck torsion bars, and other items which may interfere with the speaker's mounting. Complete speaker, mounting size and depth requirements can be found at the end of this manual. [. . . ] A good way to confirm speaker place meet on a door or body panel is to place the speaker's die cast mounting ring onto the surface. A plastic cup or some heavy gauge plastic sheeting may be needed in some locations that are exposed to moisture from behind the body panel. Care must be taken to prevent low frequency cancellation caused by air leakage between the front and rear of the speaker (such as when mounted on a curved or uneven surface, or when mounted in an oversized hole). Mounting panel reinforcement may be necessary in some cases in order to prevent surface flex. This can be achieved by mounting the speaker on a metal or wooden sub-baffle behind the body or door panel. Unless you are replacing existing speakers of same size, mounting locations will have to be cut into the doors, body panels, or rear deck. In some cases speaker mounting holes will be precut in the doors, body panels, or rear deck steel. IMPORTANT: Never cut any metal that is an integral part of an automobile's safety or structural supportsystem. Proceed to insert mounting screws through the loudspeaker mounting assembly and use the provided screw clips to capture the screw. Place the speaker grille within the basket and mounting ring and make sure the grille makes contact with the grille mounting adhesive. Component systems mid/bass speaker with injected cone 25 mm soft dome tweeter with silk edge separate frequency crossover with integrated tweeter protection solid grille for effective speaker protection Coaxial systems mid/bass speaker with injected cone integrated 13 mm mylar tweeter integrated tweeter protection solid grille for effective speaker protection DB 69. The products are carefully checked and tested during the entire production process. In the case of service note the following: 1) The 2 years warranty period commences with the purchase of the product and is applicable only to the original buyer. 2) During the warranty period we will rectify any defects due to faulty material or workmanship by replacing or reparing the defective part at our decision. Further claims, and in particular those for price reduction, cancellation of sale, compensation for damages or subsequential damages, are excluded. The warranty period is not altered by the fact that we have carried out warranty work. [. . . ] The warranty period is not altered by the fact that we have carried out warranty work. 3) Unauthorized tampering with the product will invalidate this warranty. 4) Consult your authorized dealer first, if warranty service is needed. [. . . ]