User manual HOLMES HCH4920

[. . . ] DO NOT use it in areas where gasoline, paint, or flammable liquids are used or stored. 12. Use appliance only for intended household use as described in this manual. Any other use not recommended by the manufacturermay cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by The Holmes Group may cause hazards. [. . . ] When finished setting the temperature, release the button and the display will flash to indicate the thermostat will be set to that temperature. The display will return to existing room temperature and gradually increase until the room has reached your pre-set temperature. If the unit will not start in the AccuTempTM mode, please make sure the "set temperature" is higher than the current room temperature. NOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to raise the thermostat setting. When the preset temperature is made, the fan will run for 30 seconds without heat. This cool down process ensures an accurate and consistent temperature reading. If you unplug the heater, you will have to reset the AccuTempTM thermostat again by following the above instructions. If you want the heater to run continuously, turn the Manual/AccuTemp switch to Manual and adjust the mode control to LO(Low) or HI(High). TM CLEANING/MAINTENANCE During Season Care: Always unplug the heater, before moving or cleaning. After cleaning, be sure to completely dry the unit with a cloth or towel. Holmes recommends that you store the unit in its original carton. ® TROUBLESHOOTING If your heater fails to operate: · Make sure the electrical outlet or circuit breaker is working. If your heater fails to oscillate: · Make sure the oscillation switch is in the full-circle position. Please see the Warranty for Service Instructions. SETTING THE THERMOSTAT 1. You need to set thermostat on HI(High) to start heater (See fig. #1 and #2). When the desired temperature/comfort level is reached, lower the thermostat setting until the fan/heater stops operating. The control will now automatically maintain the pre-set temperature level by turning the heater ON and OFF. Note: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to raise the thermostat setting. Figure 1 A B I C D Figure 2 ACCUTEMPTM CLOSE-UP A. OSCILLATION SWITCH MODE CONTROL THERMOSTAT HEAT CONTROLS OFF LOW 1000W FAN HI 1500W TEMPERATURE RANGE DISPLAY G H SERVICE INSTRUCTIONS 1. Do NOT attempt to repair or adjust any electrical or mechanical functions on this unit. If you need to exchange the unit, please return it in its original carton, with a sales receipt, to the store you purchased it. If you are returning the unit more than 30 days after the date of purchase, please see the enclosed warranty. [. . . ] Carefully pack the item in its original carton or other suitable box to avoid damage in shipping. Before packing your unit for return; be sure to enclose: a) your name, full address with zip code and telephone number, b) a dated sales receipt or PROOF OF PURCHASE, c) your $8. 00 check for return packaging, and d) The model number of the unit and the problem you are having. (Enclose in an envelope and tape directly to the unit before the box is sealed. ) 3. Holmes recommends you insure the package (as damage in shipment is not covered by your warranty). [. . . ]