User manual HOLMES HM2408

[. . . ] HM2408UC05EFM1. qxd 5/26/05 08:17 Page 1 TROUBLESHOOTING F R E Q U E N T LY A S K E D Q U E S T I O N S TROUBLE Unit does not turn on Mist output minimal to none Filter turns brown PROBABLE CAUSE Not plugged in Filter has not absorbed water The filter has absorbed minerals SOLUTION Plug in unit Wait 15 minutes for filter to absorb water Replace your filter (HWF62) by calling 1-800-5-HOLMES, or visit www. holmesproducts. com REPLACEMENT ACCESSORIES REPLACEMENT ACCESSORIES To order the replacement accessories you can do any of the following: · Fill out the accessories card found with the product · Visit your local retailer · Go to www. holmesproducts. com · Call consumer service at 1-800-5-HOLMES SERVICE INSTRUCTIONS 1. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. If you need to exchange the unit, please return it in its original carton, with a sales receipt, to the store where you purchased it. If you are returning the unit more than 30 days after the date of purchase, please see the enclosed Warranty. [. . . ] After 60 minutes of use, FilterCheck® Indicator will move and indicate your filter condition. After frequent Figure 2 use of your humidifier, the FilterCheck® Indicator will let you know when the filters need to be changed, see Figure 2. When the needle is in the CHANGE section, this means the proper amount of moisture is not getting into your air due to the excessive minerals and sediment that have become trapped on your filters. It is important to change your filter as indicated to obtain stated performance level. It will take about 30 minutes for the humidifier to reach maximum output. You can purchase replacement filters (model HWF62) at a local retailer, by calling 1-800-5-HOLMES, filling out the accessory card, or by visiting www. holmesproducts. com. It is recommended that a replacement filter is purchased for uninterrupted use. DAILY MAINTENANCE 1. Be sure the unit is OFF and is disconnected from the electrical outlet. Remove the housing and the tank from the humidifier and place in sink or tub. Carry the base of the unit to the sink, remove the wick, place in sink, drain any remaining water and rinse thoroughly to remove any sediment or dirt. Drain the water from the tank into the sink and rinse tank thoroughly. Put filter back in, replace the housing, then refill tank with cool tap water as instructed earlier in the Filling Instructions. Be sure the humidifier is switched to OFF and the unit is disconnected from the electrical outlet. Select a location for your humidifier, on a flat surface, about 4" away from the wall. DO NOT place the humidifier on a finished floor or near furniture, which can be damaged by moisture or water. Place on a moisture-resistant surface. Figure 1 D B F A C E H G STORAGE INSTRUCTIONS When not using your humidifier for an extended period of time: 1. Clean, rinse and thoroughly dry the humidifier as directed in weekly maintenance. Leaving water in the unit may render the unit inoperable for the following season. Place the humidifier in the original carton and store in a cool, dry place. Order your replacement filter for next year's use. PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS Consumer Safety Information NOTE: This is an electrical appliance and requires attention when in use. NOTE: If moisture forms on the walls or windows of the room, turn off the humidifier. The room already has plenty of humidity and additional moisture may cause damage. [. . . ] Vous pouvez surveiller l'état du filtre de votre humidificateur en vérifiant l'indicateur FilterCheck®. Après une période d'utilisation d'environ 60 minutes, l'indicateur FilterCheck® Figure 2 se déplacera et indiquera l'état du filtre. Un filtre neuf indiquera un relevé dans la section marquée «GOOD», qui signifie un bon filtre. Consultez la figure 2. CE PRODUIT EST ÉQUIPÉ D'UNE FICHE POLARISÉE c. a. [. . . ]