User manual HUMAX F2-FOX

[. . . ] ** ** ** ** ** Notice ** Copyright (Copyright © 2001 HUMAX Corporation) Not to be copied, used or translated in part or whole without HUMAX's prior consent in writing except approval of ownership of copyright and copyright law. ** Warranty The information in this document is subject to change without notice. HUMAX does not have any responsibility for direct, indirect, accidental, necessary and other damage due to your offer or use of the information contained in this manual. ** Trademarks VIACCESSTM is a trademark of France Telecom. 'Dolby' and the double-D symbol are trademarks of Dolby Laboratories. This receiver manufactured under license from Dolby Laboratories. ** ** Thank you for purchasing a HUMAX satellite receiver. [. . . ] Select your desired Age Level using the the OK button button, button, and press ** ** ** GB 36 ** ** ** ** ** ** ** ** ** ** ** ** View All 7 12 15 18 Lock All All programmes can be watched because there is no age limitation. All Programmes are blocked without considering the age level. Note: You have to enter Password to watch the programme which is blocked by the age level. ** 2. Setting Allow Watch Time You can block programmes according to the watching time for all the channels. Select Enable or Disable the Allow Time Control using the button, and press the OK or button. Disable Enable You can watch whenever you want regardless of Allow Time. You can watch only while the time specified by Allow Time. ** 3. When you have selected Enable, set the Start and End Time using the NUMERICAL (0~9) buttons, and press the OK button 4. If you wish to cancel the entered time, select the Cancel button, and press the OK button. Note: Once the setting has been completed, you can watch programme only while the time specified by Allow Time. Or you should enter the Password to watch any programme during unspecified time. ** ** ** GB 37 ** ** ** ** ** ** ** ** ** ** 7. Enter New Password using the NUMERICAL (0~9) buttons, and press OK button. Enter the New Password again to confirm the Verify Password, and press the OK button. If you have forgotten your Password, please contact your local product distributor. 7. 2 Language Setting You can set Language for Menu, Audio, and Subtitle. Menu/Audio/Subtitle Language ** You can set the language for Menu, Audio and Subtitle. Select your desired option and press the OK Language Dolby Digital Watch programme in the selected language. However, it you select Dolby Digital, you cannot change the language. ** ** ** GB 38 ** ** ** ** ** ** ** ** ** ** ** ** 3. Subtitle Display ** You can select whether or not to display the Subtitle if provided. Select your desired option and press the OK Subtitles are displayed automatically in the predefined subtitle language. Subtitles are displayed in the language when you select the subtitle language by pressing the SUBTITLE button at remote controller. 4. Select your desired option and press the OK Variable Uses the horizontally variable Subtitle Font. Uses the fixed Subtitle Font. ** Fixed Font ** 7. 3 Time Setting You can specify the current time and Power On/Off time. Select Time Setting using the or button. ** ** ** GB 39 ** ** ** ** ** ** ** ** ** ** 7. [. . . ] Note: If the CS Antenna is covered with snow or the RF is weaken by heavy rain, sound and picture may temporarily be poor. However, these poor sound and picture quality because of weather conditions cannot be not accepted as a malfunction of equipment. - Replace LNB with the one with low noise factor if the noise factor is high. No or poor sound ** ** ** - Check the volume level of the TV and Receiver. [. . . ]