User manual HUMAX FOXSAT-HD

[. . . ] freesat HD Digital Satellite Receiver User's Manual FOXSAT-HD The default password is 0000. Notice Thank you for purchasing a HUMAX product. Please read this user's manual carefully to be able to safely install, use and maintain the product at maximum performance. Keep this user's manual next to your product for future reference. The information in this user's manual is subject to change without notice. Copyright (Copyright © 2010 HUMAX Corporation) Not to be copied, used or translated in part or whole without HUMAX's prior consent in writing except approval of ownership of copyright and copyright law. Warranty The warranty does not cover parts which may become defective due to misuse of the information contained in this manual. Trademarks · Manufactured under license from Dolby Laboratories. [. . . ] · Other functions will not activate while software update takes place. Software update while watching a programme When new software is detected, you can choose to download the software immediately or save for later. In case there is no software currently available, select Next and press the OK button to proceed to the next step. 2. Software update via USB host Copy the software to the USB memory stick and connect the USB to the receiver. To power on, press the STANDBY button while switching on the receiver to start software update. GB48 User's Manual 12. Settings TV Setup Language Time Parental Control Other STB Mode 1. Appendix 12. 2 Trouble Shooting Before contacting your local service centre, please read the tips below carefully. If the problem persists after completing the following procedure, please contact your local retailer for further instructions. No message displayed on the front panel (the product will not switch on) · · · · · · · · · · · · · · Check the main power cable and make sure it is plugged into a suitable power outlet. (Press the STANDBY button) Make sure that the AV cable is firmly connected to the TV. Make sure that the antenna cable is properly connected to the product. Make sure there is no mobile phone or microwave oven near the product. Keep the power and the antenna cable for the satellite apart from each other. Check the signal levels and adjust your antenna if the level is too low. Poor picture/sound quality Note: If the antenna is covered with snow or the RF is weakened by heavy rain, the condition of the sound and picture may temporarily be poor. However, the poor sound and picture quality due to weather conditions cannot be accepted as a malfunction of product. · · · · · · · · · · · · Check that your dish alignment is correct. Change the satellite dish for a larger one as this will increase the signal levels received. Replace the LNB with a lower noise factor in cases where the noise factor is too high. To control the product, the top end of the remote control should point directly towards the receiving part of the product. Check that no previous reservations are conflicting with the new reservation. 4. Channel search does not work. · · Make sure that the antenna setting in the menu is correct. If there is no message displayed requesting an update, there is no software available for your product at that time. 9. [. . . ] If the distribution and/or use of the Library is restricted in certain countries either by patents or by copyrighted interfaces, the original copyright holder who places the Library under this License may add an explicit geographical distribution limitation excluding those countries, so that distribution is permitted only in or among countries not thus excluded. In such case, this License incorporates the limitation as if written in the body of this License. The Free Software Foundation may publish revised and/or new versions of the Lesser General Public License from time to time. Such new versions will be similar in spirit to the present version, but may differ in detail to address new problems or concerns. [. . . ]