User manual HUMAX FTV-5600

[. . . ] Safety This STB has been manufactured to satisfy the international safety standards. MAINS SUPPLY OVERLOADING LIQUIDS CLEANING VENTILATION : 190 - 250V AC 50/60Hz : Do not overload a wall outlet, extension cord or adapter as this may result in fire electric shock. : The slots on top of the STB must be left uncovered to allow proper airflow to the unit. Do not expose the STB to direct sunlight or do not place it near a heater. [. . . ] If you change the current service, your STB will initially select the previously memorized Audio Language. If the Audio Language of current service is not provided, at this time, you should reselect a language on the Audio Language menu. Languages provided: English, Deutsch, French, Italian, Spanish and so on. If no language is provided, then the default language of current service will be automatically selected. Subtitle Language Select the default language for Subtitle when changing services. Language provided: English, Deutsch, French, Italian, Spanish and so on. 16 Guide of Main Menu 2. Time Setting You can set the Current Time and Wakeup/Sleep Time in this mode. When a VCR is connected, recording can be automatically done according to Wakeup/Sleep Time Setting. Current Time To set the Current Time, enter the Offset value using the standardised information of current service area. The time setting will be used as the standardised time for the I-Plate, TV Guide, Wakeup and Sleep timer. Time Offset Current time is based on TDT (Time and Data Table) at the stream of the current service. Use the Numeric buttons(0~9) on the remote control unit to enter your Wakeup Time. Sleep Time Depending on time setting, select the time when STB is turned off. Use the Numeric buttons(0~9) on the remote control unit to enter your Sleep Time. Use the buttons to select "Disabled". 17 OSD Setting Select the OSD transparency for information box and the display time. Info. Box Display Time Set the display duration of Information Box displayed on the screen after changing services. The time ranges from 0 to 20 seconds. Parental Control You can set a parental guidance rating to each programme in this mode. When the button is pressed after selecting the highlighted parental control on the initial menu screen, a display window for entering the PIN Code will appear on the centre of screen. Enter the PIN Code " 0 0 0 0 " on the display window and press the button. (If any problem occurs when entering a PIN Code, you cannot switch to the next mode. ) 3. Set the parental guidance rating of highlighted censorship classification. The parental level is given as age-based numbers : no block, All block, 6, 10, 14 and 18. [. . . ] Check that you have selected the correct channel or Video Output on your TV. If you are using the RF Output, check that you have correctly tuned the UHF channel of the STB or TV. Check the signal level, if this is low then try adjusting the alignment of your dish. If you are using a DiSEqC 1. 0 switch, check that you have connected the LNBs to the correct connections on the switch. [. . . ]