User manual HUMAX HDCI-2000

[. . . ] Notice Copyright (Copyright © 2007 HUMAX Corporation) Not to be copied, used or translated in part or whole without HUMAX's prior consent in writing except approval of ownership of copyright and copyright law. ** Warranty This warranty does not cover parts which may become defective due to misuse of the information contained in this manual. ** Trademarks VIACCESSTM is a trademark of France Telecom. 'Dolby' and the double-D symbol are trademarks of Dolby Laboratories. ** This product incorporates copyright protection technology that is protected by U. S. Use of this copyright protection technology must be authorized by Macrovision, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision. The information in this document is subject to change without notice. GB 1 Notice Read this manual carefully and make sure you understand the instructions provided. [. . . ] Access to installation menu is permitted without password. GB 43 8. Setting 8. 2 Language Setting Language Setting enables you to set the basic language options such as menu language, subtitle display and subtitle font. Menu Language Menu Language allows you to choose from the given language options and set the language for the menu. Subtitle Display Subtitle Display allows you to show the subtitles automatically. Select one option from Auto and Manual using the OK Auto Manual or button. Subtitles are displayed automatically in the predefined subtitle language. Subtitles are displayed when you press the OPT+ button on the remote control and set subtitle. GB 44 3. Subtitle Font Subtitle Font enables you to select the font of the subtitle. Select one option from Variable and Fixed using the OK Variable Fixed Uses the horizontally variable subtitle font. or button. 8. 3 Time Setting Time Setting allows you to set the current time or set the time you want to turn on/off the product. Select Yes and press the OK Note: · The current time is set automatically whenever GMT offset changes. · GMT can be changed in 30 minutes/1 hour units. GB 45 8. Power On You can set the time you want the product to be automatically turned on. Select Enable/Disable using the OK Enable Disable ** Uses Power On and sets the time the product should be turned on. and press the OK ** Note: To enter a radio channel in Channel No. , press the TV/RADIO button to switch to radio. 3. Power Off You can set the time you want the product to be automatically turned off. Select Enable/Disable using the OK Enable Disable ** Uses Power Off and sets the time the product should be turned off. When you select Enable, enter the Time using the or NUMERIC(0-9) buttons. Then, select OK and press the OK button. ** Note: Once Power On/Off has been set, it is repeated everyday. GB 46 8. 4 A/V Setting You can set the output of the audio or video. Select one option among CVBS, RGB and S-Video using the OK or button. 2. i Display Time You can set the automatic display time of the information box when the channel is switched. Select a value between Disable , 1~ 20 seconds using the OK or button. ** Note: When set to Disable, the i-plate will not be displayed when you switch the channel. 2. Select one option among Disable, 25, 50 and 75 using the OK Disable Fully opaque screen or button. 25, 50, 75 The bigger the number, the more transparent the screen. GB 48 9. [. . . ] Insert a different CI module to check if your existing module is working. Replace LNB. The channel is scrambled or not available. The channel has a signal, but no audio or video is provided. CI module not installed. The channel has a video signal, but no audio is provided. LNB is internally short. Alien substance is inserted in LNB IN port and Remove the alien substance and contact local port may be damaged. [. . . ]