User manual HUMAX ICORD HD

[. . . ] Please read this user's manual carefully to be able to safely install, use and maintain the product at maximum performance. Keep this user's manual next to your product for future reference. The information in this user's manual is subject to change without notice. Copyright (Copyright © 2007 HUMAX Corporation) Not to be copied, used or translated in part or whole without HUMAX's prior consent in writing except approval of ownership of copyright and copyright law. Warranty The warranty does not cover parts which may become defective due to misuse of the information contained in this manual. Trademarks · · · · · · Viaccess is a trademark of France Telecom. `Dolby' and the double-D symbol are trademarks of Dolby Laboratories. This product incorporates copyright protection technology that is protected by U. S. [. . . ] Installation LNB Power Select Standard or High and press the OK button. Transponder Set the transponder to check the signal status. If the required value is not available, select User Define and enter the transponder value directly. 4. Enter the value for Frequency, Polarization, Symbol Rate, Transmission, Modulation and FEC. Select Done and press the OK button to complete. Frequency Enter the frequency using the NUMERIC(0-9) buttons. Polarization Select among Auto, Horizontal and Vertical and press the OK button. Symbol Rate Select the symbol rate and press the OK button. If the required symbol rate is not available, select User Define and enter the symbol rate directly. Transmission Select DVB-S or DVB-S2 and press the OK button. Modulation Select QPSK or 8PSK and press the OK button. GB59 User's Manual 9. The values for Symbol Rate and FEC differ depending on the value of Modulation. Parameter Transmission Modulation Symbol Rate FEC DVB-S Disabled 2-45Ms/s Auto, 1/2, 2/3, 3/4, 5/6, 7/8 QPSK 10-30Ms/s Auto, 1/2, 2/3, 3/4, 3/5, 4/5, 5/6, 8/9, 9/10 Value DVB-S2 8PSK 10-31Ms/s Auto, 3/5, 2/3, 3/4, 5/6, 8/9, 9/10 GB60 User's Manual 9. Installation 9. 2 Antenna Setting [SCD Antenna] MENU Installation Antenna Setting [SCD Antenna] SCD Antenna Single Cable Distribution enables the delivery of broadcast programming over a single cable to multiple users eliminating the numerous cables required to support other electronics devices. If you are using more than one satellite receiver, set one receiver at a time and turn off the others while setting. Enter the value for Tuner1, Band Frequency, Tuner2, Band Frequency and Satellite Setting. Band Frequency When selecting User Band 1-8 in SCD Antenna, the default value is displayed. Note: If SCD Antenna is enabled, 22kHz Tone and DiSEqC Input are disabled. Tuner 2 Select from User Band 1-8 and press the OK button. GB61 User's Manual 9. Band Frequency When selecting User Band 1-8 in SCD Antenna, the default value is displayed. Enter the value for Satellite, LNB Frequency, LNB Power, Satellite Position and Transponder. Select Save and press the OK button to complete. Satellite Select the satellite the antenna is pointing to and press the OK button. If the required satellite is not available, select User Define and enter the name of the satellite directly. LNB Frequency Select the LNB frequency value and press the OK button. If the required value is not available, select User Define and enter the LNB frequency directly. Note: If you select Universal, the 22kHz Tone will be disabled. LNB Power Select Standard or High and press the OK button. Satellite Position Select Position1 or Position2 and then press the OK button. Transponder Select the value for the transponer. If the required value is not available, select User Define and enter the transponder value directly. GB62 User's Manual 9. Installation 9. 3 Antenna Setting [Motor] MENU Installation Antenna Setting [Motor] 1. Motor Setting You can set the motor antenna for efficient channel search. [. . . ] Each transponder can be used for distribution of several channels or services. 23. PIP (Picture In Picture) A function that allows you to display two different TV channels (or TV inputs) on a single screen. 24. PVR (Personal Video Recorder) Video recorder that can record and playback programmes directly using the embedded hard disk drive(s). 25. Trick-Play Pause, Fast Forward/Fast Rewind, Slow Motion, Instant Replay, Commercial Skip, Repeat A-B. 26. [. . . ]