User manual HUMAX ICORD HD PLUS

[. . . ] HD Digital Recorder User's Manual iCord HD+ The default password is 0000. Notice English Thank you for purchasing a HUMAX product. Please read this user's manual carefully to be able to safely install, use and maintain the product at maximum performance. Keep this user's manual next to your product for future reference. The information in this user's manual is subject to change without notice. Copyright (Copyright © 2010 HUMAX Corporation) Not to be copied, used or translated in part or whole without HUMAX's prior consent in writing except approval of ownership of copyright and copyright law. Warranty The warranty does not cover parts which may become defective due to misuse of the information contained in this manual. Meaning of Symbols To reduce the risk of electric shock, do not remove cover (or back). [. . . ] Select Automatic Update and press the OK button to search for new software. When new software is detected, select Yes to start the update process now. Manual Update You can update software via another transponder. When new software is detected, select Yes to start the update process now. When completing the software update, the product is automatically powered off and on again. Menu On/Off Select Confirm Enter 0~9 68 Installation English Note: · It may take 5~10 minutes to update software. · Other functions such as scheduling programmes will not activate while software update takes place. · Be sure to update software when the signal strength and quality is high. If the weather is not favorable and the signal strength and quality are not recommendable, perform the software update later. · The product will search new software automatically during standby. If new software is detected, you can choose either to download immediately or later when you switch into operation mode. If you select Later, the message will be displayed again when you power on. · You can also update the software by connecting a USB device which has the new software file. · Software update through the network is also possible if the network is connected through the LAN. Caution: · Please be careful to keep the power on and the power cord plugged in during software update. If the power is off during software update, fatal damage may be caused to the product. · Please be careful not to pull out the signal line (RF cable) during software update. Update may be interrupted and the product may not operate. Factory Default MENU Settings Installation Factory Default 1. If you have forgotten your password, please contact your local distributor. Warning: Please note that once you perform Default Setting, all data such as antenna setting information, channel list, and all user configured data will be deleted. After completing the default setting, the installation wizard will appear automatically in a few seconds. Menu On/Off Select Confirm Enter 0~9 69 System In System, you can view the information of the system, signal detection, Smartcard, CI-Module and data storage. Power management, TVTV EPG and network options are also available in this section. Press the BACK button to return to the previous screen. System Information MENU Settings System System Information The system information is displayed. Signal Detection MENU Settings System Signal Detection You can check the signal strength and quality of the searched channels. Note: This menu will not be activated while recording. Menu On/Off Select Confirm Enter 0~9 70 System Power Management MENU Settings System Power Management English Setting Power Saving in Standby You can minimise the standby power consumption to below 1W. [. . . ] It is not the purpose of this section to induce you to infringe any patents or other property right claims or to contest validity of any such claims; this section has the sole purpose of protecting the integrity of the free software distribution system which is implemented by public license practices. Many people have made generous contributions to the wide range of software distributed through that system in reliance on consistent application of that system; it is up to the author/donor to decide if he or she is willing to distribute software through any other system and a licensee cannot impose that choice. This section is intended to make thoroughly clear what is believed to be a consequence of the rest of this License. If the distribution and/or use of the Library is restricted in certain countries either by patents or by copyrighted interfaces, the original copyright holder who places the Library under this License may add an explicit geographical distribution limitation excluding those countries, so that distribution is permitted only in or among countries not thus excluded. [. . . ]