User manual HUMAX LGB-23DCNL

[. . . ] This symbol indicates important instructions accompanying the LCD-TV. Read this manual carefully and make sure you understand the instructions provided. Throughout the whole manual, pay special attention to the following marks that indicate hazardous situations. Indicates additional information to the user to make the user aware of possible problems and information of any importance to help the user to understand, to use and to maintain the installation. The information in this document is subject to change without notice. Copyright (Copyright 2004 HUMAX Corporation) Not to be copied, used or translated in part or whole without HUMAX's prior consent in writing except approval of ownership of copyright and copyright law. Warranty HUMAX does not have any responsibility for direct, indirect, accidental and other damage caused by the use of the information contained in this manual. Trademarks VIACCESSTM is a trademark of France Telecom. 'Dolby' and the double-D symbol are trademarks of Dolby Laboratories. [. . . ] Game Menu Map Trouble Shooting Specification Glossary Service and Support 28 29 29 29 29 30 31 32 32 32 35 36 36 37 38 39 39 40 42 43 43 44 45 46 46 49 50 50 50 51 51 52 54 57 58 59 Please see page 4 to refer to the LCD TV contents 27. Digital TV-Contents 1. Digital TV Channel Setup When you purchase your LCD-TV, you can run the Automatic Search. It immediately performs Channel Search. (You can also run the digital TV channel setup in Default Setting. ) 1. If the Channel Search is stopped or finished, press the OK ( ) button to save the result of the channel search. Once the channel search has finished, you can enjoy digital television. Warning : If you exit the Automatic Search without fully completing the channel searching procedure, you may not have any digital TV channels stored. In this case, you can use the Installation Menu to configure your LCD-TV as required. 28. Digital TV Channel Setup 2. Basic Operation This chapter describes functions such as switching channel, changing language, and basic features for watching programmes. 2. 1 Switching Channel You can switch the current channel using one of the following methods. 1. Enter your desired channel number using the NUMERICAL (0~9) button to move to the channel directly. ) button to switch between TV Note : You can switch channel using the channel list or programme guide. 2. 2 Change the Subtitle Language If the current programme provides Subtitle information, you can select the language for the Subtitle. 1. Select your desired subtitle language using the / button, and press the OK ( ) button. Then the subtitle will be displayed in the selected language at the bottom of the screen. _ Whenever you press the DTV CH ( / ) buttons to move on ) button ) or RADIO CH ( while the channel list is displayed, the channel list will be switched between the TV and Radio channel list. 3. 2 Edit Channels You can edit all channels or each channel by channel list group. 1. Select Edit Channels using the / button, and press the OK ( ) or button. Select Edit Channel Lists using the / button, and press the OK ( ) or button. Note : _ Press the BACK ( ) or button to save the changes and return to the previous menu, press the ( ) button to exit the menu screen. _ You can easily navigate all menus using the assigned number for each menu. Press the MENU then select DTV Setup and then the numbers 2, 1 to select Edit Channel List menu. 32. Select a Channel Group You can select the channel list group to edit TV or Radio. 1. Select your desired channel list group using the / button, and press the OK ( ) button. Note : _ Press the DTV CH ( ) or RADIO CH ( RADIO channel list directly. )button to move to TV or _ For editing Favourite channel list, move to DTV Setup - Edit Channels Edit Favourite Channels menu. 2. Delete Channels You can delete one or more channels. 1. Select Delete in the right using the button, and press the OK ( ) button. 33. Lock/Unlock Channels You can lock or unlock one or more channels. 1. Select/Unselect All Channels You can select/unselect all channels at a time. 1. [. . . ] Menu Map Menu Map LCD TV Menu Mode Brightness Contrast Sharpness Colour Colour Temperature Effect Bass Treble Balance Auto Volume Level SRS WOW Sound Source Auto Programme Manual Programme Edit Programme Picture Sound Analogue TV Channel Digital TV Setup Digital Channel Main Input PIP/TWIN PIP/TWIN Input PIP Position Swap Language Time Setting OSD Transparency AV2 Output Antenna Power Aspect Ratio Backlight Brightness PIP/TWIN System PC Main Menu Auto Configure Position Clock Phase RGB Input Setting 53. Menu Map Trouble Shooting Before contacting your local service dealer, please make sure you refer to the following guide. If the LCD-TV does not work normally after completing the following trouble shooting, please contact your local LCD-TV distributor or service centre. 1. No message is displayed on the front panel or the LCD-TV has no power + Check the main power cable and check that it is plugged into a suitable power outlet. [. . . ]