User manual HUMAX VACI-5350

[. . . ] VACI-5350 Digital Set-Top Box for Viaccess Embedded & Common Interface Standard Contents Safety. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 ~ 30 Safety This STB has been manufactured to satisfy the international safety standards. MAINS SUPPLY OVERLOADING LIQUIDS CLEANING VENTILATION : 190 - 250V AC 50/60Hz : Do not overload a wall outlet, extension cord or adapter as this may result in fire electric shock. : The slots on top of the STB must be left uncovered to allow proper airflow to the unit. [. . . ] Current Time To set the Current Time, enter the Offset value using the standardised information of current service area. The time setting will be used as the standardised time for the I-Plate, TV Guide, Wakeup and Sleep timer. Time Offset Current time is based on TDT (Time and Data Table) at the stream of the current service. Use the Numeric buttons(0~9) on the remote control unit to enter your Wakeup Time. If you do not want Wakeup Time, then select "Disabled" mode using the buttons. Sleep Time Depending on time setting, select the time when STB is turned off. Use the Numeric buttons(0~9) on the remote control unit to enter your Sleep Time. If you do not want Sleep Time, then select "Disabled" mode using the buttons. 14 Guide of Main Menu OSD Setting Select the OSD transparency for information box and the display time. Info. Box Display Time Set the display duration of Information Box displayed on the screen after changing services. The time ranges from 0 to 20 seconds. Parental Control You can set a parental guidance rating to each programme in this mode. When the button is pressed after selecting the highlighted parental control mode on the initial menu screen, a display window for entering the PIN Code will appear on the centre of screen. Enter the PIN Code " 0 0 0 0 " on the display window and press the button. (If any problem occurs when entering a PIN Code, you cannot switch to the next mode. ) 3. The parental level is given as age-based numbers : No block, All block, 6, 10, 14 and 18. To change your PIN Code: · Enter a New PIN Code in the highlighted New PIN Code using the buttons. · To verify the New PIN Code, re-enter a New PIN Code in the highlighted Verify PIN Code and press the button. When the entered PIN Code is correct, then all settings are completed. 15 AV Output Setting Video Output (CVBS/S-Video/RGB) Set the Video mode for the TV SCART output. Audio Output Set the Audio mode which is output from the TV SCART and RCA/Cinch Jack. (Stereo/Mono) Dolby Digital If Dolby Digital option is ON and the broadcaster provides the Dolby Digital stream, the Dolby Digital audio language is firstly selected when changing the service. Screen Mode Select the aspect ratio of TV which is connected to STB (4:3 or 16:9). Display Format Select the format which the video is to be displayed on screen. When your TV set is 4:3 and video source is 16:9, STB will display in Letter-Box or Centre mode as selected. [. . . ] If you are using the RF Output, check that you have correctly tuned the UHF channel of the STB or TV. Check the signal level, if this is low then try adjusting the alignment of your dish. If you are using a DiSEqC 1. 0 switch, check that you have connected the LNBs to the correct connections on the switch. Check the "Signal Strength" and the "Signal Quality" in the Signal Status menu. [. . . ]