User manual HUSQVARNA 185CD

[. . . ] Your emission control system includes Parts such as the carburetor and the ignition system. Where a warrantable condition exists, Husqvarna Forest & Garden will repair your small nonroad engine at no cost to you. nearest authorized servicing dealer or call Husqvarna Forest & Garden at 1-800-487-5963. WARRANTY PERIOD Any warranted part which is not scheduled for replacement as required maintenance, or which is scheduled only for regular inspection to the effect of “repair or replace as necessary” shall be warranted for 2 years. [. . . ] c) Conserve water by using power blowers instead of hoses for many lawn and garden applications, including areas such as gutters, screens, patios, grills, porches and gardens. The blower must not be used while on a ladder or scaffolding. MAINTENANCE 1. In order to maintain your product in proper working order, perform the maintenance and checking operations described in the manual at regular intervals. Always be sure to turn off the engine and disconnect the spark plug before performing any maintenance or checking procedures. WARNING The metallic parts, engine cover, and area around the engine reach high temperatures immediately after stopping the engine. Examine the blower at intervals for loose fasteners and rusted or damaged parts. Use special care around the fuel line, the muffler, and the ignition wiring. All engine service except for those described in this manual should be performed by competent service personnel. Improper service to the blower fan and muffler could cause a hazardous failure. When replacing the any other part or any lubricant, always be sure to use only Husqvarna products or products which have been certified by Husqvarna for use with the Husqvarna product. In the event that any part must be replaced or any maintenance or repair work not described in this manual must be performed, please contact the nearest Husqvarna servicing dealer for assistance. Do not use any accessory or attachment other than those bearing the Husqvarna mark and recommended for the unit. A correctly adjusted harness and machine significantly facilitates the work. Adjust the harness to give the best working position. F8 Tighten the side straps so that the pressure is evenly distributed across the shoulders. F9 WAIST BELT • The waist belt is attached to the rings on the left and right sides of the frame. F10 Place the waist belt over your waist and not too far down on the stomach. Tighten the waist belt strap so that you feel the weight of the blower resting on your hip. • Be sure to always tighten the buckle in front of your body. F11 WARNING • If you are not using a waist belt, be sure to remove it from the unit and store it. • There is a risk that the belt will be caught, toppling the unit. • There is a danger that the belt will be sucked into the fan. F12 11 English Fuel FUEL WARNING • Gasoline is very flammable. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 10ft (3m) away from the fueling point before starting the engine. • The engines are lubricated by oil specially formulated for aircooled 2-cycle gasoline engine use. If Husqvarna oil is not available, use an anti-oxidant added quality oil expressly labeled for air-cooled 2-cycle engine use. (JASO FC GRADE OIL or ISO EGC GRADE) • Do not use BIA or TCW (2-stroke water-cooling type) mixed oil. [. . . ] Exchange the paper filter element with new one in case it has been contaminated. WARNING • • • • This prefilter is dry type. Do not clean the paper filter by tapping on it. FUEL FILTER • A clogged fuel filter may cause poor acceleration of the engine. The filter can be taken out of the fueling port using a small wire hook. Disconnect the filter assembly from the fuel pipe and unhook the retainer to disassemble it. [. . . ]