User manual HUSQVARNA 246 BIO

[. . . ] Keep hands and feet away from the cutting means at all times and especially when switching on the engine. Do not attempt any maintenance on your lawnmower when the engine is hot. Release the blade brake lever, to stop the engine, wait until the blade has stopped, disconnect the spark plug lead and wait until the engine has cooled:- before leaving the mower unattended for any period; - before refuelling - before clearing a blockage; - before checking, cleaning or working on the appliance; - if you hit an object. Do not use your lawnmower until you are sure that the entire lawnmower is in a safe operating condition; - if the lawnmower starts to vibrate abnormally. [. . . ] Move the axles between the notches to achieve the desired cutting height. Add oil as necessary to keep the level to the FULL mark on the dipstick. Change the oil after the first five hours operation and thereafter every 25 working hours. Always change the oil while the engine is warm but not hot - never attempt any maintenance on a hot engine. To avoid introducing dirt into the fuel system, wipe all grass and dirt from the petrol filler cap before unscrewing it. It is recommended that you fill the tank through a funnel with a filter. Starting the cold engine Push primer bulb firmly 3 times before starting cold engine. (Also, if engine stopped because it ran out of fuel, refuel engine and push primer 3 times). Starting the warm engine NOTE: Priming is usually unnecessary when restarting a warm engine. Pull the blade brake lever all the way to the upper handle before you start the engine. Due to engine lubrication limitations, the mower should not be used on slopes in excess of 300. (P) Before mowing objects such as twigs, toys and stones should be removed from the lawn. (Q) Avoid running the blade over foreign objects such as stones, roots, etc. Never cut more than 1/3 of the length of the grass, especially during dry periods. Always remove the spark plug lead before repair, cleaning or maintenance work. All nuts, bolts and screws should be checked for tightness after 5 hours use. Push the handle down to ground level when tilting the mower for cleaning purposes. ANNUALLY Always handle the blade with care - sharp edges could cause injury. Renew your metal blade after 50 hours mowing or 2 years whichever is the sooner - regardless of condition. When reassembling the blade ensure that the retaining washer is flat and not dished, tighten the bolt to a torque of 35-40 Nm. Remove the blade to gain access to the oil drain plug, open the drain plug underneath the mower and let the oil run out. The engine brake cable should always be adjusted to stop the engine within 3 sec. [. . . ] Once petrol has been replaced, it may take a little time for fresh petrol to filter through. If the engine still lacks power and/or is overheating, immediately disconnect the spark plug lead. ENGINE SERVICING & GUARANTEE The engine fitted to your lawnmower is guaranteed by the Engine Manufacturer. We strongly recommend that your product is serviced at least every twelve months, more often in a professional application. [. . . ]