User manual HUSQVARNA 322 E

[. . . ] 322E/325E-X Operator’s manual (CARB, EPA) Read through the Operator‘s manual carefully and understand the content before using the machine. 101 89 75-95 SYMBOL EXPLANATION Symbols WARNING!Careless or incorrect use can result in serious or fatal injury to the operator or others. • Arrows which show limits for handle mounting. • Always wear approved protective gloves. Read through the Operator‘s Manual carefully and understand the content before using the machine. [. . . ] Children, animals, onlookers and helpers should be outside the safety zone of 15 meters (50 feet). The bevel gear unit can get hot during use and may remain so for a while afterwards. There is a risk of slight burns if you touch it. 10 – English SAFETY INSTRUCTIONS Safety instructions after completing work • Ensure the blade has stopped before cleaning, carrying out repairs or an inspection. • Only use original spare parts with repair. English – 11 WHAT IS WHAT? 1 4 21 4 20 1 26 24 What is what on the edger? 1. Blade Grease filler cap Angle gear Blade guard Shaft Loop handlebar Throttle Stop switch Throttle trigger lock 15. Air purge 12 – English ASSEMBLY Assembling the loop handlebar • Position the handle on the shaft. • Fit the bolt, securing plate and wing nut as shown in the diagram. • Tighten the wing nut. Assembling the blade Fit the blade as follows: 1. Make sure that the edge that fits in the hole of the blade is facing outward. Block the blade rotation by inserting locking pin in the hole behind the blade guard engaging it in the corresponding hole in the drive disc. The support flange must be fitted with its outer edge hard up against the blade. 4. 5. 6. Assembling the angle gear • Assemble the angle gear back on the supporting tube. Do not forget to remove the locking pin before using the machine. • Position the angle gear so that its slot is aligned with the line on the supporting tube. ! WARNING!Under no circumstances may the edge cutter blade be used without the blade guard fitted. • Firmly tighten the screw. English – 13 FUEL HANDLING Fuel mixture NOTE!The edger is fitted with two-stroke engines and must always be run on a mixture of gasoline and two-stroke oil. To ensure the correct mixture proportions it is important to measure the quantity of oil accurately. When mixing small amounts of fuel small discrepancies in the amount of oil has a great bearing on the proportions of the fuel mixture. Mixture • Always mix gasoline and oil in a clean container intended for fuel. • Always start by filling half the quantity of gasoline required. • Mix (shake) the fuel mixture carefully before filling in the machine‘s fuel tank. • If the clearing saw is not used for a long period of time, the fuel tank should be emptied and cleaned. • This engine is certified to operate on unleaded gasoline. ! Gasoline WARNING!Leaded fuel will destroy the catalytic converter and it will no longer serve its purpose. [. . . ] Blade: Equivalent noise power levels measured according to prEN 31806 and ISO 10884, dB(A). Blade: 96 96 102 102 Vibration levels Vibration levels on the handles measured according to prEN 31806 and ISO 7916, m/s2 Blade, idling rear/front handles: Blade max. speed rear/front handles: 2, 0/3, 5 5, 7/6, 0 531 00 40-44 503 84 65-01 1, 4/2, 6 6, 0/4, 4 531 00 40-44 503 84 65-01 Cutting equipment Blade Blade guard English – 21 FEDERAL AND CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The EPA (U. S. Environmental Protection Agency), CARB (California Air Resources Board) and Husqvarna Forest & Garden are pleased to explain the emissions control system warranty on your 1999 and later small off-road engine. [. . . ]