User manual HUSQVARNA 455 E RANCHER

[. . . ] Operator’s manual (EPA II) 455e Rancher 455 Rancher 460 Rancher Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. English KEY TO SYMBOLS Symbols on the machine: WARNING!Careless or improper use can result in serious or fatal injury to the operator or others. Symbols in the operator’s manual: Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance. Always wear approved protective gloves. Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. Always wear: • Approved protective helmet • Approved hearing protection • Protective goggles or a visor Both of the operator′s hands must be used to operate the chain saw. Regular cleaning is required. Visual check. Never operate a chain saw holding it with one hand only. [. . . ] Air purge (B): Press the air purge repeatedly until fuel begins to fill the bulb. The bulb need not be completely filled. Grip the front handle with your left hand. Hold the chain saw on the ground by placing your right foot through the rear handle. Pull the starter handle with your right hand and pull out the starter cord slowly until you feel a resistance (as the starter pawls engage) then pull firmly and rapidly. Never wrap the starter cord around your hand B A 22 – English STARTING AND STOPPING As the chain brake is still activated the engine must return to idling speed as soon as possible by disengaging the throttle latch in order to avoid unnecessery wear on the clutch assembly. This method is very dangerous because you may lose control of the saw. Push in the choke control as soon as the engine fires and make repeated starting attempts. Do not pull the starter cord all the way out and do not let go of the starter handle when the cord is fully extended. This can damage the machine. • • Never start the machine indoors. Observe your surroundings and make sure that there is no risk of people or animals coming into contact with the cutting equipment. • Note!The right hand should be on the rear handle, and the left hand on the front handle. Use a firm grip with thumbs and fingers encircling the chain saw handles. ! • WARNING!Long term inhalation of the engine’s exhaust fumes, chain oil mist and dust from sawdust can represent a health risk. Stopping Never start a chain saw unless the bar, chain and all covers are fitted correctly. Without a bar and chain attached to the chain saw the clutch can come loose and cause serious injury. Stop the engine by switching off the ignition. English – 23 WORKING TECHNIQUES Before use: • To make sure that none of the above might come within reach of your saw or be injured by falling trees. , 1 2 3 4 5 6 7 8 9 Check that the chain brake works correctly and is not damaged. Check that all parts of the chain saw are tightened correctly and that they are not damaged or missing. Follow the instructions above, but do not use a chain saw in a situation where you cannot call for help in case of an accident. 2 Do not use the machine in bad weather, such as dense fog, heavy rain, strong wind, intense cold, etc. Working in bad weather is tiring and often brings added risks, such as icy ground, unpredictable felling direction, etc. Take great care when removing small branches and avoid cutting bushes (i. e. Small branches can be grabbed by the chain and thrown back at you, causing serious injury. 3 10 Check the chain tension. General working instructions IMPORTANT!This information is never a substitute for professional skills and experience. If you get into a situation where you feel unsafe, stop and seek expert advice. Contact your chain saw dealer, service agent or an experienced chain saw user. [. . . ] Serious injury to the operator, helpers, bystanders or any combination of these persons may result from one-handed operation. A chain saw is intended for two-handed use. With a basic understanding of kickback, you can reduce or eliminate the element of surprise. Keep a good firm grip on the saw with both hands, the right hand on the rear handle, and the left hand on the front handle, when the engine is running. Use a firm grip with thumbs and fingers encircling the chain saw handles. [. . . ]