User manual HUSQVARNA CARDINAL 3507610

[. . . ] Protective goggles or a visor This product is in accordance with applicable EC directives. Noise emission to the environment according to the European Community's Directive. The machine's emission is specified in chapter Technical data and on label. Regular cleaning is required. Symbols in the operator's manual: Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance. [. . . ] Even a non-moving chain can cause serious cuts to yourself or persons you bump into with an exposed chain. Clean the area around the fuel cap. Make sure the fuel is well mixed by shaking the container before refuelling. The capacities of the chain oil tank and fuel tank are carefully matched. You should therefore always fill the chain oil tank and fuel tank at the same time. · · · · ! WARNING!Be aware of the risks of fire, explosion and those associated with inhalation. Long-term storage Empty the fuel/oil tanks in a well ventilated area. See instructions under the heading Maintenance schedule. Fuel safety · · · Never refuel the machine while the engine is running. Make sure there is plenty of ventilation when refuelling or mixing fuel (petrol and 2-stroke oil). Move the machine at least 3 m from the refuelling point before starting it. 18 ­ English STARTING AND STOPPING Starting and stopping Warm engine Use the same procedure as for starting a cold engine but without setting the choke control in the choke position. The correct choke/start throttle setting is obtained by moving the choke control to the choke position and then pushing it in again. ! WARNING!Note the following before starting: The chain brake must be engaged when the chain saw is started to reduce the chance of contact with the moving chain during starting. Never start a chain saw unless the bar, chain and all covers are fitted correctly. Follow the instructions above, but do not use a chain saw in a situation where you cannot call for help in case of an accident. 2 Do not use the machine in bad weather, such as dense fog, heavy rain, strong wind, intense cold, etc. Working in bad weather is tiring and often brings added risks, such as icy ground, unpredictable felling direction, etc. Take great care when removing small branches and avoid cutting bushes (i. e. Small branches can be grabbed by the chain and thrown back at you, causing serious injury. 10 Check the chain tension. General working instructions IMPORTANT!This information is never a substitute for professional skills and experience. If you get into a situation where you feel unsafe, stop and seek expert advice. Contact your chain saw dealer, service agent or an experienced chain saw user. Before using a chain saw you must understand the effects of kickback and how to avoid them. Before using a chain saw you must understand the difference between cutting with the top and bottom edges of the bar. See instructions under the headings How to avoid kickback and Machine's safety equipment. [. . . ] When the switch is pushed upwards, the heat is switched off. Electrical carburettor heating (357 XPG, CARDINAL 3507610 G) On models with the designation CARBURETOR HEATING there is an electrically heated carburetor. Electrically powered heating prevents ice formation in the carburetor. A thermostat regulates the heating so that the carburetor always has the right working temperature. English ­ 37 MAINTENANCE Maintenance schedule The following is a list of the maintenance that must be performed on the machine. Weekly maintenance On chain saws without a catalytic converter, check the cooling system weekly. [. . . ]