User manual HUSQVARNA CT153

[. . . ] Please read these instructions carefully and make sure you understand them before using this machine. ⷠNever allow children or people unfamiliar with the instructions to use the lawnmower. ⷠNever mow while people, especially children, or pets are nearby. ⷠKeep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. [. . . ] Never leave the key in the ignition lock when leaving the machine on its own. To release the parking brake all that is necessary is to push down the brake pedal. Do not smoke when filling with petrol or fill up when the engine is warm. The combined oil refilling cap and the oil stick is accessible when the bonnet is lifted forwards. If more oil is needed add SAE 30 oil to the "FULL " marking. SAE 5W-30 oil should be used during the winter (below freezing point). Ensure that the cutting unit is raised to the highest position and that the control for connection/disconnection of the cutting unit is in the disconnection position. The machine is equipped with a safety switch which immediately breaks the current to the engine if the driver leaves the seat with engine running and with the connection/disconnection control in position "connection". Your machine is also equipped with a system that will not allow mower to operate if the bagger or optional rear discharge deflector is not installed properly. If the engine will not start, wait about 10 seconds before the next try. Let the ignition key return to the "ON" position when the engine has started Push the gas control to the required speed. ⷠRetain the plug assembly by connecting the two straps into the holes provided on the bagger support arms. Insert the discharge chute into the opening in the backplate and onto the mower deck adaptor. ⷠTo continue mowing, be sure bagger is down and in proper operating position which will allow mower to operate. Switching off the engine move the attachment clutch control to disengaged position. Move the throttle control between half and full speed (fast) position. Lift up the cutting unit and turn the ignition key to "STOP" position. Do not leave the ignition key in the machine when not in use to prevent children and other unauthorized persons starting the engine. Before servicing the engine or cutting unit the following shall be carried out: · Grasp hood at sides, tilt forward and lift off of tractor. NOTE: Periodic maintenance should be performed on a regular basis in order to keep your tractor in good running condition. WARNING: Disconnect spark plug wire to prevent accidental starting before attempting any repair, inspection, or maintenance. Check to see all bolts, nuts, and cotter pins are in place and secure. [. . . ] Start the belt from above steering support plate (6) on the left side of the steering shaft. Work the belt onto the engine pulley (4) and under the belt guide (5). The transaxle should be in neutral when the gear shift lever is in neutral (lock gate) position. The adjustment is preset at the factory; however, if adjustment is needed, proceed as follows: · NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position. [. . . ]