User manual HUSQVARNA EDGER

[. . . ] Monteer de meenemer (G) op de transmissiehuisas en roteer de meenemer tot de opening voor de borgpen zich vlak voor de opening in het transmissiehuis bevindt. Steek de borgpin in de opening in het transmissiehuis en verder in de opening in de meenemer. This accessory may only be used together with the intended clearing saw/ trimmer, see under heading "Approved accessories" in chapter "technical data" in the machine's Operator's Manual. [. . . ] Never use a machine that has parts missing or has been changed in relation to the specification. â· Ensure no one comes closer than 15 metres when working. â· Never allow anyone else to use the machine without first ensuring that they have understood the contents of the Operator's Manual. Safety instruction while working â· Always make sure you have a safe and firm foothold. Make sure hands and feet do not come into contact with the blade when the engine is running. When the engine is switched off keep hands and feet well away from the blade until it has stopped. Safety instructions after completing work â· Ensure the blade has stopped before cleaning, carrying out repairs or an inspection. First place the blade guard (A) on the angle gear (B), see the diagram. There is a slot on the guard that fits to a guide flange on the gear housing. Fit the clamp (C) on the opposite side against the guard, on the angle gear. It should be possible for the blade guard to rotate on the gear housing. Rotate the guard on the gear housing until the hole on the gear housing for the locking pin (F) is visible. Fit the drive disc (G) on the gear housing axle and rotate the drive disc until the hole in the drive disc aligns with the hole in the gear housing. Insert the locking pin through the hole in the gear housing and into the hole in the drive disc. [. . . ] The flexible drive axle is easily removed from the shaft by taking a firm grip on the axle end. lubricate the flexible drive axle over its entire length and reinsert it in the shaft. Turn the axle while inserting it so that it correctly engages in the clutch. [. . . ]