User manual HUSQVARNA H352F 52 COLLECTION SYSTEM

[. . . ] Study the operating instructions and safety precautions thoroughly to insure proper functioning of your Grass Catcher and to prevent injury to yourself and others. Engine exhaust, some of its constituents, and certain vehicle components contain or emit chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. WARNING!The operation of any mower can result in foreign objects thrown into the eyes, which can result in severe eye damage. ALWAYS wear safety glasses or eye shields before starting your mower and while mowing. [. . . ] Always wear safety glasses or eye shields while operating your mower or performing any adjustments or repairs. We recommend a wide vision safety mask over spectacles or standard safety glasses. Never store the machine or fuel container inside where there is an open flame, such as a water heater. • • CHILDREN Tragic accidents can occur if the operator is not alert to the presence of children. • • • • Keep children out of the mowing area and under the watchful care of another responsible adult. They may fall off and be seriously injured or interfere with safe machine operation. Use extra care when approaching blind corners, shrubs, trees, or other objects that may obscure vision. • • Never run a machine inside a closed area. Keep nuts and bolts, especially blade attachment bolts, tight and keep equipment in good condition. Grass catcher components are subject to wear, damage, and deterioration, which could expose moving parts or allow objects to be thrown. Frequently check components and replace with manufacturer’s recommended parts, when necessary. Wrap the blade(s) or wear gloves, and use extra caution when servicing them. Adjust and service as shown in the Operator’s Manual. • • • • • • CAUTION In order to prevent accidental starting when setting up, transporting, adjusting or making repairs, always disconnect spark plug wire and place wire where it cannot contact spark plug. • • 5 ASSEMBLY UNPACKING INSTRUCTIONS • Remove all parts and packing materials from carton. 7 CONTAINER CONTENTS • • • Blower Assembly Belt Mounting Brackets • Containers • Seal Fastening Kit • Bag of Hardware TOOLS REQUIRED • • • • • • • /16" Wrench or ratchet and socket ½" Wrench or ratchet and socket ¾" Wrench Drill and 3/8" bit Torque Wrench Hacksaw Hammer Bag Dump Indicator Upper Chute Middle Chute Belt Cover Blower Housing NOTE: When right hand (RH) and left hand (LH) are mentioned in this manual, it means when you are seated on the mower in the operator’s position. CAUTION BEFORE ASSEMBLING GRASS CATCHER TO MOWER: • Set parking brake. • Place motion control levers in “NEUTRAL” position. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug and place wire where it cannot come in contact with plug. 6 ASSEMBLY 1 DECK ADJUSTMENT 3 MOUNTING BLOWER ASSEMBLY 1. Locate the rear adjustment nut on the discharge side of the deck. 2. Using the mark as a guide, turn the nut clockwise five turns with a ¾" wrench. 1. Remove the discharge chute from the deck. 4. Position blower over the discharge tabs on the deck and set blower onto the deck. 5. Be sure the blower is sitting flush against the outside of the deck. Rear Mount Bracket 2 BAGGER SUPPORT ASSEMBLY Contact Area 8063-072 1. Slide the flanges of the support assembly in the slots in the drawbar. 6. Install the front mount bracket to the deck with the pin and hairpin cotter supplied with the kit. Support Assembly 8063-085 Hairpin Cotter 2. Pivot the assembly backwards to insert the bottom pin into the drawbar. Pin Outer Pulley Cover 8063-073 Hairpin 8063-086 7 ASSEMBLY 4 INSTALLING DRIVE BELT 6 INSTALLING CHUTE SUPPORT 1. Make sure the tension release lever is forward (disengaged). Tension Release Arm Outer Pulley 1. Position upper chute support against bagger inlet, flush at outer edges. [. . . ] a. Disengage blades, place motion control levers in neutral position. - Reassemble and latch chutes. • • • GENERAL RECOMMENDATIONS Always observe safety rules when performing any maintenance. • See BLADE CARE instructions in your mower operator’s manual. STORAGE When grass catcher is to be stored for a period of time, clean it thoroughly, remove all dirt, grass, leaves, etc. Store in a clean, dry place. 11 REPAIR PARTS 57 45 6 62 39 48 51 16 13 40 25 4 61 15 47 29 34 31 52 5 41 34 7 51 48 39 37 19 49 54 9 60 53 50 10 12 11 22 43 49 42 44 23 42 55 26 21 38 35 33 12 38 14 24 56 59 49 17 14 38 20 26 18 55 35 33 34 8 58 36 1 46 27 32 30 61 28 3 2 45 REPAIR PARTS ITEM PART NO. QTY. DESCRIPTION ITEM PART NO. QTY. DESCRIPTION 1. . 539 130344. . . . [. . . ]