User manual HUSQVARNA HAU15H42A

[. . . ] YTH1542XP Owner’s Manual Safe Operation Practices for Ride-On Mowers IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. SAFETY RULES • I. GENERAL OPERATION • • • • • • • • • • • • • • • • Read, understand, and follow all instructions in the manual and on the machine before starting. Only allow responsible adults, who are familiar with the instructions, to operate the machine. [. . . ] • The engine should not start unless the clutch/brake pedal is fully depressed and attachement clutch control is in the disengaged position. • When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine. • When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine. • The attachment clutch should never operate unless the operator is in the seat. BLADE CARE For best results mower blades must be kept sharp. Replace bent or damaged blades. 5/8" BOLT OR PIN BLADE BLADE REMOVAL (See Fig. 11) • • • Raise mower to highest position to allow access to blades. Install new or resharpened blade with trailing edge up towards deck as shown. FIG. 12 BATTERY Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life. NOTE: The original equipment battery on your tractor is maintenance free. TO CLEAN BATTERY AND TERMINALS Corrosion and dirt on the battery and terminals can cause the battery to “leak” power. IMPORTANT: TO ENSURE PROPER ASSEMBLY, CENTER HOLE IN BLADE MUST ALIGN WITH STAR ON MANDREL ASSEMBLY. • • Reassemble hex bolt, lock washer and flat washer in exact order as shown. torque). IMPORTANT: BLADE BOLT IS GRADE 8 HEAT TREATED. 16 CUSTOMER RESPONSIBILITIES • • • • • • Remove terminal guard. Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor. Reinstall battery (See “REPLACING BATTERY" in the SERVICE AND ADJUSTMENTS section of this manual). • Remove yellow cap from bottom fitting of drain valve and install the drain tube onto the fitting. OIL DRAIN VALVE V-BELTS Check V-belts for deterioration and wear after 100 hours of operation and replace if necessary. Replace belts if they begin to slip from wear. TRANSAXLE COOLING The transmission fan and cooling fins should be kept clean to assure proper cooling. Do not attempt to clean fan or transmission while engine is running or while the transmission is hot. To prevent possible damage to seals, do not use high pressure water or steam to clean transaxle. • Inspect cooling fan to be sure fan blades are intact and clean. • Inspect cooling fins for dirt, grass clippings and other materials. To prevent damage to seals, do not use compressed air or high pressure sprayer to clean cooling fins. CLOSED AND LOCKED POSITION YELLOW CAP DRAIN TUBE TRANSAXLE PUMP FLUID The transaxle was sealed at the factory and fluid maintenance is not required for the life of the transaxle. Should the transaxle ever leak or require servicing, contact your nearest authorized service center/department. FIG. [. . . ] Bolt Fin Hex 3/8-16unc x 1 Gr. 5 Bolt Rdhd Sqnk 3/8-16unc x 1 Pin Head Rivet Bracket Asm Whl GA R LH Bar Adjusting GA WHL Bolt Carr 5/16-18 x 5/8 Bracket Asm Whl GA R RH Bracket Asm Whl GA F RH Bracket Asm Whl GA F LH Bracket Arm Idler 42” Keeper Belt 42” Clutch Cable Pulley Idler Flat Bolt Carriage Idler Spring Return Idler Retainer Spring Yellow Zinc Washer 9/32 x 3/4 x 16 Ga. Bolt Rdhd Sqn 3/8-16 UNC x 1- 3/4 Screw 3/8-16 x . 75 Mandrel Assembly (Includes Housing, Shaft and Shaft Hardware Only - Pulley Not Included) -532 17 60-50 Replacement Mower, Complete NOTE: All component dimensions given in U. S. inche 1 inch = 25. 4 mm 41 SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION SIGHTING GUIDE CUT OUT ON D THIS OTT IS A ED L 15 S INES LOP E ONLY RIDE UP AND DOWN HILL, NOT ACROSS HILL SIGHT AND HOLD THIS LEVEL WITH SKY LINE OR TREE. 42 15 MAX. Operate your Tractor up and down the face of slopes (not greater than 15 ), never across the face. Exercise extreme caution when changing direction on slopes. WARRANTY STATEMENT SECTION 1: LIMITED WARRANTY Husqvarna Forest & Garden Company (“Husqvarna”) warrants Husqvarna product to the original purchaser to be free from defects in material and workmanship from the date of purchase for the “Warranty Period” of the product as set forth below: Lifetime Warranty: All tiller tines, trimmer shafts, ignition coils and modules on hand held product. [. . . ]